I got some AG guys stuff and...

[bran987]

I just got some stuff from AG Guys, mmm not sure if this belongs on this board but you guys are experts on these bottles and such.

I got some Viagra and it's a blue solution and like 99% of the crystals are stuck to the bottom of the bottle and no matter how much I shake the crystals won't unstick themselves. I mean there are a few crystals in the solution but not many at all.

How do I unstick them?

Thanks!

 

[PolfaJelfa]

Did you try heating ir bro?

 

[bran987]

Did you try heating ir bro?

won't that change the chemical composition or something? ( i have no idea if i should heat it or not )

 

[Tux]

No, heating it won't change the chemical or break it down. Just heat it gently in warm/hot water, see if they redisolve.

 

[PolfaJelfa]

I dont believe it will ( it has to be heated pretty damn high( boiling or more ) for the chemical composition to change).....but just to be safe better get some imput from the chemists here as im not positive.

 

[azul]

No, heating it won't change the chemical or break it down. Just heat it gently in warm/hot water, see if they redisolve.

And then shake it like a Polaroid picture! Yes, I am ghey...

 

[nomad12]

Ok on there site it says something to this extent. Bring water to the point right before it boils. Then place the bottle in the water ( Id say only enuff water to cover a little more than half of the bottle) then return to heat and let it warm up to a slow boil and then remove. Use gloves cause it will be hot. Whatever you do dont use a microwave.

 

[bran987]

Ok on there site it says something to this extent. Bring water to the point right before it boils. Then place the bottle in the water ( Id say only enuff water to cover a little more than half of the bottle) then return to heat and let it warm up to a slow boil and then remove. Use gloves cause it will be hot. Whatever you do dont use a microwave.

thank you very much mr. nomad

 

[genarr3]

When you heat it make sure you have a pin in the rubber stopper so pressure doesn't bulid up.

 

[bran987]

When you heat it make sure you have a pin in the rubber stopper so pressure doesn't bulid up.

little late for that, good thing it didn't bust

 

[RADAR]

I used an ice pick on mine!

Scraped it off shook ( the bottle fools) nixed right up

RADAR

 

[silverbackn]

And then shake it like a Polaroid picture! Yes, I am ghey...

That was humorous.