Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

hole in stopper wont close wtf?

burnthiscorpse

Plat Hero
Platinum
so i noticed earlier that the 4 vials i transfered last night all still had a tiny hole in them in the rubber stopper!!
I transfered from plastic to glass. vented with a 21g during transfer and baking. now you cant "really" see the hole except a little tiny spot. But when I tip them upside down i get little tiny air bubbles. and when i go to turn them back over I get one little drop out the hole!!
WTF, this is not acceptable? is it going to contaminate my gear? do i need to order more goddamn vials and transfer and bake again??
suggestions would be greatly appreciated.
 
so i noticed earlier that the 4 vials i transfered last night all still had a tiny hole in them in the rubber stopper!!
I transfered from plastic to glass. vented with a 21g during transfer and baking. now you cant "really" see the hole except a little tiny spot. But when I tip them upside down i get little tiny air bubbles. and when i go to turn them back over I get one little drop out the hole!!
WTF, this is not acceptable? is it going to contaminate my gear? do i need to order more goddamn vials and transfer and bake again??
suggestions would be greatly appreciated.

Noway to avoid that really when you use presealed vials. Plenty of people use that method and it works out fine. Next time try using a smaller gauge needle to vent. No use in going bigger than 23g, 22 max. helps a bit, but not much.
 
Top Bottom