help

[allan-h]

lads i need ur help ,i do my shots my self using deca and enanthe with 5 ml barrel and 1 ince pin ,,,its so fcking hard to push in the juice ,,i only managed to get half of it in and then i switched to the 1inch and a half pin it still wasnt any easyer it keeps happing me whats up

 

[allan-h]

its a 23g and 1 inch.also when u inject do u keep the pressure on it constintly or do u push hard and wait and push hard and wait and push hard to stop a build up of it thanks.

 

[conundrum]

This site was very helpful for me....SpotInjections.com

 

[stevesmi]

u probably have an air bubble

are you leaving room in the syringe to push the oil up and then pushing it all the way up till oil starts coming out before injecting?

 

[C.K.]

work out your hands more

 

[allan-h]

always one ha ha c.k.

iv noticed that when i push the oil to the top and let it flow out a little there is like a little bubble lust where the pin sits over the tip of the barrel but i cant get to go could that be it

 

[stevesmi]

flick it and move the plunger up and down

 

[Zyglamail]

A little air in the syringe isnt gonna make it hard to inject, you pushing a thickish oil through a small needle, slow and steady wins the race dont try and squeeze like your using a super soaker, have some patience.

 

[DaBangEm]

Man just slow down and apply slow and steady pressure. Zyg's right, lol, it's not a super soaker. I usually count to 30 as I'm breathing and injecting. I even pin slowly too. I usually take about 10 seconds or so just for that. And adding length to your pin won't change it. I have zero problems with a 25 g so you should be g2g with a 23 g.

 

[RADAR]

A little air in the syringe isnt gonna make it hard to inject, you pushing a thickish oil through a small needle, slow and steady wins the race dont try and squeeze like your using a super soaker, have some patience.

I agree ,it takes me almost a full minute to inject 2 cc's using a 25G pin.