Help with transfering thick gear

[GarrisX]

im trying to transfer my gear, which is an oddly thick test. and its really been a b itch to do so.

the first time i did it, it took forever and i eneded up losing some of my gear as it practically exploded out of the pin.

im tyring to transfer it to a sterile multi-use vile from its container.

what would make it easier?

heating the test?

and if so how do i do this?

or is there a way i could poor it directly into the drawing syring and then put the needle on it to put it into the vile?


thanks for any replies

 

[enacer420nj]

why not just use an 18g draw pin?

 

[GarrisX]

i am using an 18g, its just so thick that it makes it nearly impossible to draw it out

 

[bw1]

You could try and heat it. To thick to draw through an 18g?

 

[GarrisX]

it comes out but its very slow and theres built up pressure that makes it like wanna push back down into the vial and squirt the gear back in

 

[bw1]

it comes out but its very slow and theres built up pressure that makes it like wanna push back down into the vial and squirt the gear back in

Inject a little air in the vial, then draw. Pull the plunger back a little, put it in the vail, push some air in, then pull the gear out.

 

[GarrisX]

alright ill try that, thanks for the tip

 

[GUARDIAN]

Inject a little air in the vial, then draw. Pull the plunger back a little, put it in the vail, push some air in, then pull the gear out.

+1

 

[GarrisX]

worked like a charm, thanks a lot guys