Help with slightly botched Rev200 conv

[UA_Iron]

The brownish tint is probably due to some kind of oxidation process - doesn't mean it's bad... just be careful with it

 

[goin on 4T]

4ml BA (since you have BA at 2.5%, this is acceptable I suppose)
32ml BB (should be at 20% with prop)
109.46ml Carrier oil (preferably GSO as goin on 4T mentioned)
16g Test prop powder

for a total of 160ml @ 100mg/ml.

Thanks UA I can't believe I screwed up my measurement.

 

[1stateofmind]

So I should keep my ba the same and add 20 ml of bb? And I assume tren and test prop are pretty much universal? And the bb is the primary solvent right?

 

[goin on 4T]

Yes increase the BB leave the BA the same.
Actually test p is harder to work with than tren a. because it has a much higher melting point approx. 250 vs 177 C.

 

[1stateofmind]

Really appreciate the help!! I feel soo much better about what I have now. I'll get everything together and see how it goes. Thanks again.

 

[goin on 4T]

No problem we have all been in your shoes.

 

[1stateofmind]

Quick question. How many of the .2 filters should I get?

 

[goin on 4T]

I would get two 250ml just incase you have a problem.

 

[1stateofmind]

I'm confused. I was assuming the .2 filters were the syringe mounted ones. Or are we talking about the same thing?

 

[goin on 4T]

I'm confused. I was assuming the .2 filters were the syringe mounted ones. Or are we talking about the same thing?

Yeah I guess I never use those. Then I would get 4.