Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Help with making fina

Hoover

New member
Hey I am new to making fina. I got my kit and pellets handy. I got the directions from a***** which seem a little different from on the website. On the website it shows on step #13 using a coffee filter to let it filter overnight and then ring out the filter with using gloves, but this is not the case on the direction sheet that he sent me. Is it a must to use the coffee filter and let it sit over night?
 
Don't use the coffee filter, and no need to let it sit overnight. You can if'n you wanna, but there is no need.
 
Thanks Txlonghorn, you were the guy I was hoping that would respond. I am going to start it now. Wish me luck.
 
May the Gods of Trenbolonia smile upon your endeavors, and bless you with a most muscular frame, the strength of ten men, and the abs of Brad Pitt. :)

How was that for a wishing of luck?
 
TxLonghorn said:
May the Gods of Trenbolonia smile upon your endeavors, and bless you with a most muscular frame, the strength of ten men, and the abs of Brad Pitt. :)

Thats really funny! I'm just got my kit too and would'nt mind a few pointers. THANKS in advance DIENBIG:D
 
Actually, letting it sit overnight helps with the filtering process. I have found it is much easier to get through the syringe filter and it turns out a much clearer final product.
 
Mechanic, when u let it sit overnight, did u have to use the coffee filter like it shows on the website? And did u let it sit overnight with just the magic solution and then add the oil to it? I am having problems with mine right now. The pellets do not want to break up. I have it in the oven now.
 
Add the pellets to the solution and put the vial in boiling water for a few seconds, take out and swirl it around. Repete until tabs are disolved. Do not over heat it or it will start to discolor. This takes about 10 minutes. Add the oil, shake it up, and let it sit overnight. Then extract the solution and fiter into new vial.
Go to anabolic extreme archives #3 for complete info and pictures.
 
Mr Coffee

I think any fina kit provider should also suggest the use of a Mr Coffee coffee grinder. It is the absolute best thing to grind your pellets into a very fine dust, allowing them to dissolve within minutes of their introduction to the 'magic solution', no hot water, no microwave needed.

Good Luck with your bovine.

Later
Rugger
 
Top Bottom