Trying to get everything in order for a cycle and just looking to understand a few more things such as best time to take a cycle, how, and the always mentioned pct.
24 yr old Male
200lb
~23% BF
1- I understand I have a high BF and was planning on doing a cut, however would it be best to cycle then cut with new muscle mass, or cut then cycle to recomp?
2- From my understanding the typical cycle on H-Drol is as follows;
Cycle Assist - Load 1 week prior and continue through cycle to 5th week before starting PCT
HDrol -
1st week @ 50mg
2nd - 6th week @ 75mg
PCT -
Nolvadex/Tamoxifen @ 20mg 6th&7th week / 10mg @ 8th&9th week
Inhibit-E @ 3caps @ 10th&11th week / 2caps @ 12th week / 1cap @ 13th week
Any recommended changes or is this looking pretty strong? I also have pre-purchased Bioforge/T-Bol from a previous order ... should I run those instead of the Inhibit or keep with the plan?
24 yr old Male
200lb
~23% BF
1- I understand I have a high BF and was planning on doing a cut, however would it be best to cycle then cut with new muscle mass, or cut then cycle to recomp?
2- From my understanding the typical cycle on H-Drol is as follows;
Cycle Assist - Load 1 week prior and continue through cycle to 5th week before starting PCT
HDrol -
1st week @ 50mg
2nd - 6th week @ 75mg
PCT -
Nolvadex/Tamoxifen @ 20mg 6th&7th week / 10mg @ 8th&9th week
Inhibit-E @ 3caps @ 10th&11th week / 2caps @ 12th week / 1cap @ 13th week
Any recommended changes or is this looking pretty strong? I also have pre-purchased Bioforge/T-Bol from a previous order ... should I run those instead of the Inhibit or keep with the plan?

Please Scroll Down to See Forums Below 










