Fina boiling and testing mgs per cc

[shrad6]

Ok how Effective and Important is it to bake and cool 3 times to try and kill the bacteria? Where do yous go to get it checked out to find out the real mg's per CC?

 

[totallyjacked]

bump

 

[RICOSUAVE]

ok I have done both methods and I have found no difernce while using it, that is , in both methods the ingection does not hurt or get infected, the oly diference I have notice ist that the none heating method yeld a more golden in color and clear tren

 

[Iceburg]

I don't believe the heating process is necessary. Maybe i've missed them - but I can't remember seeing a single post where someone got an infection from homebrew tren. Don't bake it.

 

[drgoodbody]

[Bthe only diference I have notice ist that the none heating method yeld a more golden in color and clear tren [/B]

That is correct. Tren tends to oxidize and turn a brownish-redish color when heat for a prolonged period. That is why Fina is often shipped to you with a cold pack. Does this effect potency? Nope, doesn't seem to, at least that's the evidence from hundreds if not thousands of users who've posted on many, many, boards.

DrG

 

[ALL41]

it is shipped 2 you with a cold pack while in pellet form, it must be kept cold to help keep the pellets together (binders and glues) since you probably wont be needing them in pellet form any longer you dont need 2 keep it cold. As far as the baking process goes, I do it every time why take the chance of having dirty fina, all the filtering and whatnot is 2 filter the good from the bad it is in no way a sterilizing process thats what the baking is for... and 2 find out the real mg per ml, each kit is intended 2 yeild 75mg per ml.. 2000mg tren = 1 cart / 2g conversion kit is needed and will convert to 75mg per ml.

 

[Saint7]

I beg to differ with you. the .22 micron filter filters out the bacteria that may be present however there are some smaller but the risk comes if tainted, ie a spoild contaminated batch. Just my .02, saint7

 

[ALL41]

I beg to differ with you. the .22 micron filter filters out the bacteria that may be present however there are some smaller but the risk comes if tainted, ie a spoild contaminated batch. Just my .02, saint7

what about the bacteria (during the converting process) in the air, your HANDS, the syringe pkg, the box it was shipped in, the cold pak that was probably sitting in their freezer for god knows how long, the bowl, mortar, or straw used 2 crush pellets, none of this is even close 2 sterile I can go on and on here... I would bake it bro, it doesn't hurt it so why not.. I'm sure others will tell u no need either but think of what I just pointed out.. just my thought on the matter, everybody is entitled 2 their own of course..
Peace

 

[Lift Chief]

You can pastuerize your gear by putting it in a pan of water and heating it to 160 degrees F- for 30 mins. That is what RG recommended to sterilize gear... Also if you want to be extra safe i would run it through a .2 micron filter so that you get any bacterial spores that can't be killed by the amount of heat you would use to sterilize your tren.

 

[Zyglamail]

As for testing concentration you would need to send it to a lab. What stated by the kit makers basically assumes you have a set amount of liquid, a set amount of tren and it all gets suspended, simply math then dictates what concentration you "should" have.