Draw pinz

[enacer420nj]

I use a 20g 1 1/2" to draw and use a new one every inject. Im running low but at the end of my cycle. How many of you guys reuse the same draw pin by just recapping and putting back in the package?

Next question I am dropping test cyp from my cycle and upping the prop.

300mg test prop
480mg Primo

I am doing M W F injects.
1.3ml primo
1ml test prop

Today I did the entire inject in my glute but for quads and delts im gonna have to split it up. Would you just shoot 1ml of the mixed primo/prop in one quad and the rest in the other and same with delts?

 

[Burpees]

I use the same one I draw with to pin, and that's usually through two rubber stoppers since ive never ran one compound only. rarely do I have to change the pin because it doesn't go through the skin easily. I use terumo brand.. I wouldn't re-use, but in all honesty if you're putting it through a sterile stopper into a clean vial and putting it back in the original cap it *should* be sterile.. I wouldn't fuck around..

 

[enacer420nj]

I use the same one I draw with to pin, and that's usually through two rubber stoppers since ive never ran one compound only. rarely do I have to change the pin because it doesn't go through the skin easily. I use terumo brand.. I wouldn't re-use, but in all honesty if you're putting it through a sterile stopper into a clean vial and putting it back in the original cap it *should* be sterile.. I wouldn't fuck around..

So you hit two different bottles then the same pin to inject? You should use a draw pin bro that way the inject pin is sharp, less scar tissue

 

[Burpees]

So you hit two different bottles then the same pin to inject? You should use a draw pin bro that way the inject pin is sharp, less scar tissue

yea.. I do change out pins sometimes.. I pull my skin tight and inject really slow if I get any type of tension going though I change the pin.. Otherwise it's sharp enough and goes through..

I get more scar tissue in my glutes than my quads.

 

[thebigoz]

I wouldn't be reusing any pins, no matter what purpose you're using it for.

Just order more pins dude...so cheap.

 

[sonicwaste]

I always use a draw pin unless it's a slin pin... No need in that case.

One thing I also discovered when dosing from multiple vials. I draw from my tren vial .75cc then squirt into empty vial, draw from masteron vial .5cc then into same empty vial. Then draw from test vial and so on... This assure accurate dosing and that if there is a good vacuum you won't spill your tren out in masteron, etc...

When I am running low, I have re-used draw pins with no problems... But I don't make it a habit of doing so.

Also using a draw pin with something like tren assures that you don't have residue on the inject pin. Helps with tren cough

 

[enacer420nj]

anyone else wanna take a stab at both of my questions?

 

[devil deezy]

never reuse pins bro... go to a local feed store or a tractor supply u can get like 20 for 3$

 

[enacer420nj]

im not talking about re using a pin that im injecting with just using it to draw from then recapping and putting back

 

[fbodyguy02]

im not talking about re using a pin that im injecting with just using it to draw from then recapping and putting back

I have re-capped / re-used pins for DRAWING only... you are fine. Just don't use the same one for the entire cycle; change it every 2-3 times.

 

[tiggerizme]

Same here, use draw pin, inject with new one. I use the same draw pin as long as the substance stays the same.

 

[devil deezy]

yah ur fine there