clogged shot????

[thetryal]

my winny seemed to be clogged or something, when i was administering it in my quad. i was about halfway throught the shot and it seemed to be stucked or clogged. is this normal with winny or maybe am i shoting to fast??

thanks

 

[eClenbuterol]

Water based products can clog the pin. You might consider using a lower gauge of the pin to increase flow.

 

[growinsc]

my suspension was clogging bad. I heated it up in microwave for 5 seconds, and shook it up. I had no more problems after that. I was able to use a 25g again.

 

[thetryal]

i may try heating it. im using 18 to draw and 23 1" to shoot. i think my microwave my have an issue with the metal band around the top. i may try running hotwater on it, or let in sit in a small bowl .

 

[bigtravis]

Also were you sitting down when inj. in your quad? Angle of syringe may cause quicker settling.

 

[MegaDesel]

Yes, heat up a cup of water for 1-2 minutes and then set it in there.

 

[pip88]

Its the crystals in the winny happens to me all the time when I did it just use a bigger gauge.

 

[rnch]

i always heated mine in a wine glass full of hot water....makes it slide in as smooth as AAP doin' his bf.

 

[empirebuilder]

I always run mine under the tap for a little bit to warm everything up. Nothing worse than getting it all ready to plunge and you have to pull out cause of a clog.

 

[ALIN]

my winny seemed to be clogged or something, when i was administering it in my quad. i was about halfway throught the shot and it seemed to be stucked or clogged. is this normal with winny or maybe am i shoting to fast??

thanks

THIS can happen sometimes with water based drugs. You may need a larger gauge pin for injection. Slightly warming solution under warm water before injecting sometimes will help it pass easier.