BA/BB for 8g Tren

[MSA122]

Seems most of the instructions I can find now are based on kits, but I have all of my own supplies...

I was wondering for 8g of tren (1 component-th, 2 finaplix) if a ratio of 8 ml BA + 8 ml BB would be ok, or if I should change the ratio or amounts. I've made it before, but it's been awhile and think I just used BA, but have both available. More worried about everything disolving than pain, which has never bothered me too much outside of mistakenly using the solvent with some Intervet hcg once--that burned like hell subQ, switched to IM.

Also, is expecting a 90% conversion rate from pellets reasonable, or should I assume a different number when calculating my oil.

Thanks.

 

[25homes]

I would use 8G for tren to make 100ml 80mg assuming its tren ace. you really need better info on what you got how much your trying to make and at what strength. doesnt seem you really know what your doing 8ml bb might be ok 8ml ba is way to much. if it is tren ace make 100cc use 3-5ml ba 8-15ml bb use more toward the 15ml if your worried about it dissolving and cook at low temp. basic rule 3-5%ba for sterilization bb changes depending on compound 10% should be fine for tren ace 15% for sure be ok nad use a base oil. I use safflower a lot would be approx 70ml of sterile filtered saff oil with 3-5ml ba and 15ml bb cook low temp filter your good.

please give more info to be sure

 

[MSA122]

Thanks, I have no issue with the process or getting to the strength I want, just a question on the amount of BA/BB needed to disolve 8g of pellets and be sterile. The only current ratio's on basskiller (when not using the "magic solution", would have it at 16ml BA for 8G of tren ace, which seemed excessive, so was going to dilute 50/50 BA/BB, but I like your 25/75 ratio better).

The component-th is a few years old, which is why I'm mixing with new finaplix, to balance out any loss in potency.
Assuming I get 90% conversion (7.2G out of the 8, and lose 1 ml in the filter, etc.); I'll use this ratio, unless you think it needs adjusted...:
4 ml BA (5%)
12 ml BB (15%)
64 ml oil - total solution of about 80 ml at 90 mg/ml, and expect the potency will actually be closer to 75 mg/ml due to the older component th

 

[bigtravis]

get you some EO friend. It will make things alot simpler. You won't have to add any or close to none of the BB. IF YOU LIKE.

 

[MSA122]

thanks, I'm going to have to research that a bit; seems that EO is the "newer" way to go from the posts here.

 

[bigtravis]

If it kills me I will bring light to everybody I can to stay away from BB and Go with EO. BB is like VHS, BETA, 8 track.,, etc...

 

[bikenut]

What is EO

 

[PuffDawg]

Ethyl Oleate