Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply puritysourcelabs US-PHARMACIES
UGL OZ Raptor Labs UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAKUS-PHARMACIESRaptor Labs

1" into Glute too risky?

mphowells

New member
Is 1.5" really needed? i have 1" and can get 1.25" (all 23g) but can't get hold of 1.5". Just wondering if I can get away with 1". probably at about 15%bf right now.
 
better off using 1.5 in tha ass, unless your body fat is REALLY low. you shoul dbe ok with 1 inchers, just use ulters rule of thumb

both hands down and where your thumb is jab it. (upper outer glute)

thats what i do for glutes
 
You should be fine however in the future, I would buy the 1.5 inch... Good luck
 
you can...depends how much fat you have on your ass..i can tell you from experience..if you inject without it all getting into the muscle..your ass will hurt like hell for a week..
 
macrophage69alpha said:
if your lean its fine
even if someone did inject AAS into fat because their pin wasn't long enough, it would not be a waste of gear because it eventually assimilates, does it not?
 
georgie24 said:
better off using 1.5 in tha ass, unless your body fat is REALLY low. you shoul dbe ok with 1 inchers, just use ulters rule of thumb

both hands down and where your thumb is jab it. (upper outer glute)

thats what i do for glutes

"just use ulters rule of thumb

both hands down and where your thumb is jab it."
Whats that rule?
 
upper/outer aspect of glute.. 1" is fine unless you're a blob - in which case, you probably need to shed some pounds, fatty.
 
DBBT said:
even if someone did inject AAS into fat because their pin wasn't long enough, it would not be a waste of gear because it eventually assimilates, does it not?

Good question...anyone know?
 
mikefear said:
upper/outer aspect of glute.. 1" is fine unless you're a blob - in which case, you probably need to shed some pounds, fatty.

I always laugh at this. If your so fat that you need to use 1.5" pins. You need to diet not cycle. Most believe that you need more than 1" but thats all docs use.....
 
Currently injecting daily.

Yesterday tried a 1” x 25 g pin in the glute after reading this post,

Just seemed to short. Today I think I will inject into my tricepts.

Also tried to use Ulters technique of a slin pin in the guad how do you fill the slin pin? Pull out the Pluncher?
 
solidspine said:
Currently injecting daily.

Yesterday tried a 1” x 25 g pin in the glute after reading this post,

Just seemed to short. Today I think I will inject into my tricepts.

Also tried to use Ulters technique of a slin pin in the guad how do you fill the slin pin? Pull out the Pluncher?

Yes Sir, Ulter had a post on it a while back, just pull out the plunger and backfill it.
 
Vascular Freak said:
1" should be fine, though with and 1.5" pin you will get less chance of injection pain and swelling etc.

I agree 100%. I've done at least 100 glute injections using a 25g 1" pin. But on my current cycle of 200mg/ml Primo I got big painful welts on my ass after every injection until I switched to 1.5".
 
I used to use a 1 inch in glutes. 1.5 inch doesn't hurt anymore than a 1 inch does. 1.5 is the preferred method for glutes because it gets the drugs deeper into the muscle.
 
Thanks for all the responses, I decided to go with 1" and to be honest it's still hurting after doing it on Tuesday. Nothing majorly painful but I'd rather avoid injecting into fat if possible just because it takes time to dispurse when in fat (apparently). I can get 1.25" 23g so might try them, maybe the extra 0.25 will make a slight difference. At the end of the day £7 for 100 will not break the bank.
 
Top Bottom