Winny help??

[PuffDawg]

Ok i have 10 grams of winny powder and would like to know the easiest route to make this. I've read so many different ways to do it both oil and water based and i'd like to know the easiest method of how to do it and take it.
I'd like to take it orally but would also like to inject it sometimes. What would be the easiest way and what ingredients would i use and in what ratios to make this? I'm not new to powders but have never attempted winny before as i hear its tricky.

 

[golds1973]

This hormone has a screaming high melting point. For this conversion solvents will be used to bring the stanozolol into a clear solution for filtering and titration. The final result will be a suspension.

Items needed for a 1 gram conversion:
• 1 Gram winny powder
• 4.0cc PEG 300/400
• 0.45um syringe filter (2 quantity)
• 0.6ml polysorbate 80
• 0.4ml benzyl alcohol
• 14.25ml distilled water
• Beaker
• 20ml vial
• 20g pins
• 5ml syringe
• 10ml syringe


1. Mix 14.25ml of distilled water with 0.4ml benzyl alcohol.
2. Pass through syringe filter into 20ml vial.
3. Put 2ml PEG300/400 into beaker and add 0.6ml of polysorbate 80.
4. Add 1 gram of stanozolol powder to PEG/ps80 mix.
5. Heat until stanozolol clears. The heat will be very high, PEG may smoke. This is ok.
6. Allow stan liquid to cool.
7. Draw into 5ml syringe, run it through the second new syringe into the 20ml vial containing our steralized water.
8. NOTE: You can use the same syringe filter as long as the filter is completely dry.
9. As you filter the PEG/ps80/Stanozolol mix through the filter into the water it will titrate back into micronized form in the water. When this is done shake vigerously.
10. Run 2 more ml's of PEG300/400 through filter to purge.


This conversion results in 20ml - 50mg/ml sterile water based stanozolol suspension for injection.

Additional Note: After much experimentation I have found that ps80 is NOT needed. However, I have a contact who makes large volumes of this, and has found that about 1 out of 10 conversions will clump for some reason. Adding ps80 alleviates the problem, so to avoid this I have included it in the directions