why does gear keep coming out of inj. site?

[bossnuts]

I'm injecting small doses of DECA into my upper glute and whenever I pull the needle out come gear comes out. I don't want to waste any of the expensive shit. Anyone know how to keep this from happening?

 

[Slopain]

Inject Deeply.
Leave a small amount of air in the syringe to seal and push the oil into the muscle. A small amount of air .25 to .5 cc in a muscle will do no harm whatsover.

 

[bambam]

slopain that is very interesting I have never heard that aproach before, I will be sure to give it a try. I never have problems with my quads or calves, but my ass always leaks like a mofo. It pisses me off

 

[Beezers]

It's a standard medical procedure called an air lock. As long as you are in the muscle(you must asperate) the 1/4cc of air will do no harm and will force all the fluid into the muscle dispersing it. Also inject slowly. But the main culprit is probable scar tissue. How long have you been hitting this site. After a while the injections just refuse to absorb and the are becomes nearly undispensable for injections, so it has a noce hardened path to flow back up through as the injection wound doesn't close. Rotate sites and give the glute a rest. Shoot in the quads, delts, and bis for more sites thus limmiting the impact of frequent injection in one area.

 

[da big thinker]

i would say you r not going deep enuff...---fyi.with all injections,i say go deep...bury it in there,remain steady,and inject...---

 

[Thaibox]

When you're set to poke, pull the skin to the side(will close better upon release) and jam it deep like db thinker said.

 

[rocketrman]

air lock ? for bezzer

i have tried this before. but when i did it, i could not properly asperiate. the plunger went back, but no vaccum entered the case.

maybe i did something wrong. can you outline this procedure bezzers ?

 

[XBiker]

Fluid rejection is normal as the area of tissue becomes saturated with the fluid.

I normally inject all the way and leave the pin in the site for 10-15 seconds. Withdrawl the pin and immediately massage the site with a alcohol soaked cotton ball.

Loosing a little bit is no big deal.

 

[Wynn]

Don't just hang around and watch it come out after taking the needle out. Apply a napkin or cotton pad with some pressure to stop leakage.

 

[rocketrman]

blood in the hub of the needle

this is somewhat of a digression. but, can anyone tell me why i get blood in the hub of my pin when i stop injecting ?

i push the pin all the way in, asperaite & plunge. when i'm done, blood sometimes seeps up.