Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply US-PHARMACIES UGL OZ
Raptor Labs UGFREAK OxygenPharm
napsgeargenezapharmateuticals domestic-supplyUS-PHARMACIES UGL OZUGFREAKRaptor LabsOxygenPharm

What size needle do you use?

UFC22

New member
I was wondering if a 25g needle will allow for everything to pass threw? Through-out my cycles i have used 22 and 23g needles and am fine with it, however i was wondering if 25g would work well with all compounds or is it to small for the compound to go threw? On spotinjections.com they say to use 25g for and spot injections (quad,delt,bi,ect....)
 
23 for me. Some use 25 but you must heat the gear up good and it a slow process. Id like to savee my thumb and go with 23.
 
Injecting 2cc's with a 25 can take almost a minute. Meanwhile you're squeezing the syringe as hard as you can to get it to sloooooowly come out, and the shaking of your hand can cause the pin to vibrate in and out which can't be good for the flesh inside. I like a 23 for glutes because it takes only 10-15 seconds to inject. I use a 25 for quads because I don't mind the slowness when I can see what I am doing right in front of me, and a 25 in quads is virtually painless.
 
18 G with a 50cc syringe full of brontosaurus pituitary extract and gorilla growth hormone. I shoot it in my belly button EOD. I don't even need to push the plunger-my body just sucks it up on it's own as soon as the needle pierces the skin.
 
18 G with a 50cc syringe full of brontosaurus pituitary extract and gorilla growth hormone. I shoot it in my belly button EOD. I don't even need to push the plunger-my body just sucks it up on it's own as soon as the needle pierces the skin.

You must be one big fu*k, are you using BD's gorilla GH?
 
Inhibitor13 said:
I use a 25G no problem whatsoever....it takes me 10-15 sec. and I really dont have to warm up the gear.

Inhibitor
Yeah, that can be the case. With a 25 it really depends on how "thick" your gear is. When injecting in the glutes, a 23 is indistinguishable from a 25, so I just use a 23 to assure it is a smooth, fast injection.
 
I use a slin pin (gh slin igf-1 test-s) and 25g (all others). If the oil is too thick, warm the vial up before draw any out. or I have known some to draw the gear out and while not letting the actual pin hit the water, run hot water over the syringe case.
 
for test I stick a 23 and it all turns out ok. However for my dbol I have had to drop my pins down to a 16 to get the crushed up pill to pass through.













j/k
 
i was usually usin 23 but i got some 20s and i love them. they fill up so quick and it dont feel much different from a 23 just a little thicker.
 
Top Bottom