Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

What is WRONG with my TEST Enathate?

macemj

New member
I got some test (Rotexmedica) German Test Enanthate 1 ml /250 ml and there is the following problems:

1. It looks very bubbly
2. Very thick -when I pop off the top of the amp the oil/test looks like a bubble and I would expect it to pop when I put the syringe inside, but instead of pucturing the needle just moves through the clump
3. Very HARD to get the juice in the syring (extreme pressure to go back in the amp)
4. I have never had this problem
5. It takes a lot of pressure to get into my glute

Question is, if it were too thick for injection it SHOULDN'T make it up into the syringe through the needle???

Also, I have Test Propionate that is 2ml/ 100 mg and these injections are EASY. Very liquidy. Easily drawn back. Easily injected into glute.

I have total diferrent properties with the two blends?

My Test has never caught my eye as clumpy, too bubbly, thick, hard to pull back, gueyyyy.....etc

HELP - Thoughts - Answers
 
what size pin are you using?

heat the gear (hot water bath, portable heater, hold glass part of vial under hot water, hair dryer)

draw with an 18g, shoot with 23g
 
macemj said:
Do you think it is because I'm using a 22g 1 1/2 needle?

post a pic

try heating it, 22g should be fine to draw and shoot
 
I'm getting BAD lumps from mine. :(

I can hardly walk. The pain shoots from the injection site all the way to my knees. I couldn't train legs all week, couldn't even do deads lifts, had to stop my cardio, which I reallllly need (I'm fat lol).
 
Good news! The lumps on my quads are getting a lot better. I decided to pin delts & leave them alone for a while. It's paid off. I switched to sust for a bit because I was freaking about about the lumps. I want to get back on that test E & finish it up. Hopefully it was just some freak thing & the gear is good to go. I'll update in this thread. (not to thread jack, but b/c macemj & I both kinda trying to figure out if there's a problem with our gear. I'm hopeful.
 
Update:

Lumps in my quads went away. I think it was partly because it was so damned thick. I had to press really hard to get the plunger down. Forced the needle to wiggle a bit because I wasn't used to it. I switched back to my rotex from sustanon. Shot my delt, much better experience. No lumps yet. I think mine is good to go. THANK GOD!
 
Top Bottom