Tips to make injections LESS PAINFUL

[Cryptlord]

Most of this was pulled from a different forum but still great information. Post up any other tips you may have.

1) Heat up the oil prior to injection
2) Take an Ibprofen 1 hour prior to injection
3) Throw heat on the injection site after the injection
4) Massage injection site after the injection
5) ALWAYS use a fresh needle
6) Push the pin in slowly
7) Throw ice on the injection site after the injection (this one is questionable, I've gotten a variety of opinions on this matter, to me it makes sense because it increases bloodflow to the area which will help the oil dispurse I would think).
8) Sometimes gear is simply painful due to high concentrations of BA... switch to a less concentrated oil. Ex: T400 is gonna hurt ALOT more than regular 250mg/ML test enanthate.

 

[xrsist]

3 simple steps is all thats needed

1. bake your gear
2. run your vial under hot water before drawing
3. SHOOT BEFORE YOU TRAIN

 

[matty420]

no pain, no gain.

 

[chazk]

the correct way to do it after a injections would be ice,heat,ice,heat
effect is pumping in new blood then cutiing it off with ice ,then pumping in new blood with heat over and over can help with inflamation yet still keep in fresh blood to help with circulation

 

[healthfrk]

3 simple steps is all thats needed

1. bake your gear
2. run your vial under hot water before drawing
3. SHOOT BEFORE YOU TRAIN

bump

deffinately #3 for sure! i like to alternate btw heat and ice before i go to bed. all these posts are good advice other than that, not much else u can do

 

[GUARDIAN]

uSe hair dryer directly on syringe.
inject slowly
massage site for several minutes
take hot shower
work that muscle in the gym if possible

 

[hooligan2004]

another thing you can try and it worked well for me but no garentee it will work for you, i would shower and run the hot water on the injection site and rub it then hop right out the shower dry, swab, and inject and immediatly got back in the shower ran the hot water on it, worked it through and hit that muscle group in the gym right away.. i cant quite pinpoint the logic of this and why it worked but it did

 

[big.nad]

another thing you can try and it worked well for me but no garentee it will work for you, i would shower and run the hot water on the injection site and rub it then hop right out the shower dry, swab, and inject and immediatly got back in the shower ran the hot water on it, worked it through and hit that muscle group in the gym right away.. i cant quite pinpoint the logic of this and why it worked but it did

very similar to this. i (always shower b4 every inject ALWAYS) but keep the very hot water blasting on the site ur going to inject. seems to make injection painless, AND makes the actual penetration of the needle much easier aswell.

never see the need to have another shower afterwards!

 

[the_alcatraz]

what xrsist said is the closest to the truth....however, i highly doubt that u can completely eliminate that pain

 

[tical]

cut it with sterile oil!