Thinning out gear?

[Tuck]

I've got some Sust that is impossible to get out of a 23G needle. Rather than use a bigger needle, I was hoping th thin the gear.
What's the best way of doing that? What do you suggest?
Thanks

 

[eddymerckx]

I've got some Sustanon that is impossible to get out of a 23G needle. Rather than use a bigger needle, I was hoping th thin the gear.
What's the best way of doing that? What do you suggest?
Thanks

you need to get some 18g pins --draw out an amp in about 10 seconds and you should not use the same need to draw and pin anyway as if it even touches the glass it is much less sharp--ergo more pain and scar tissue build-up.

also you need not put more oil into your body than is required.

 

[xrsist]

run vial under hot water before drawing

 

[jumpmaster82]

just heat up the vial before drawing, or use a bigger pin to draw

 

[Tuck]

I use an 18G to draw, but it still is hard as hell to inject using a 23. I'll try heating it up before I use it. Thanks for the advice.

 

[chris69]

I've got some Sustanon that is impossible to get out of a 23G needle. Rather than use a bigger needle, I was hoping th thin the gear.
What's the best way of doing that? What do you suggest?
Thanks

Holy fuck,must be thick shit, organon ?, i use a 25 g 1.5 " and i just place the vial of sus on the stove above the pilot light for 15 min....I have to be carfull how fast i inj !like meted butter !

 

[needtogetaas]

I've got some Sustanon that is impossible to get out of a 23G needle. Rather than use a bigger needle, I was hoping th thin the gear.
What's the best way of doing that? What do you suggest?
Thanks

You can use a bigger needle to draw and a different one to inject. You should be using different needles for both any way.