I notice my test suspension is starting to crystalize. Is there anyway to break it up? Can you heat it up like oil in the oven? any help would be appreciated
I notice my test suspension is starting to crystalize. Is there anyway to break it up? Can you heat it up like oil in the oven? any help would be appreciated
I notice my test suspension is starting to crystalize. Is there anyway to break it up? Can you heat it up like oil in the oven? any help would be appreciated
Get a frypan, place on stove get the vial put a pin through it doesnt matter what size 23 gauge will do......this is to vent it. Heat for approx 5min or until crystals are gone then inject.
Normally, I would bring the water to a gentle boil, and back off the heat a bit until it is just near the boiling point, then set the vial in with a pin in the septum to vent off pressure for about 20 minutes or so. It is a pain in the butt figuratively but better than physically.
thanks for the help, I will do the warm water bath today. I use to but oil based aas in the oven with a pin in the top for 10mins and worked great just wasnt sure if it would be the same with water based aas. I will give the water a try.