Test Ethan still cloudy

[goin on 4T]

Test Ethan 300mg/ml still cloudy after 1 day.
2% BA
20% BB
Rest 1/2 EO and GS oil
Heated the BA & BB in a beaker in a pan with 1/2 of water added ethan
Melted all ethan than added EO and GS
Ran through milipore filter with hand pump
Seemed pretty clear after filtering
When put in individual vials (presealed) it seems to have clouded up?
What can I do to clear it up?

 

[bigtravis]

After you heat your oils and compounds let it cool completely down. The EO will hold it even at room temp. Then filter. The heat and EO may be causing your problem when passing through the filter.

 

[goin on 4T]

After you heat your oils and compounds let it cool completely down. The EO will hold it even at room temp. Then filter. The heat and EO may be causing your problem when passing through the filter.

It was cloudy when it went into the filter and clearer when it came out. But once it got into the vial it was cloudy again.
I just put 2 vials in a pan with some water and heated up to 160F for 20 min. It is as clear as a bell! If it holds I guess I will have to do them all. If it crashes again what should I do?
Thanks

 

[bigtravis]

Puzzles me. Someone else on here had the same issue. Very well could be something in the compound.

 

[goin on 4T]

Yep it went cloudy again! What should I do? Bake it?

 

[bigtravis]

Are you sending it through while warm/hot?

 

[goin on 4T]

Yes it was warm when it went through, the beakers were kept warm in hold in the oven had preset the oven to 200f. Then turned it off once it was warm. The beakers when pulled from the oven to filter were very warm but not to hot to burn hands as each of them was pulled out of the oven.
In reading the thought the heat would help the oil go through filter quicker as I read that EO can mess up your filter!
The filter that was used was:
Millipore Stericup Complete Filter Units with Durapore PVDF Membranes is this ok with EO?

 

[golds1973]

Yes EO will mess up filters! I have only had problem with things being cloudy when I have used EO with GS oil or just EO. I will not use EO unless it is for higher than normal conversions like 200mg prop. I can tell you almost for certain that your conversion is cloudy from filter damage. I have only had one conversion not become cloudy when using EO even on smaller conversions.

 

[goin on 4T]

I understand what you are saying. So why would the solution clear up when heated up? Have heated up to 250f one set of vials for over 1hr and those are the clearest!

 

[golds1973]

not sure could be moisture.