Test 500 Npp 300

[Gboyt]

Looks like this might be my next cycle in spring. But i have a few questions

1. How long should this combo be ran for?

2. Will i need to increase my ai dose?
I took arimidex at .25mg eod last time i ran test at 500mg with success and plan to do the same thing this time around

3. Is gyno going to be an issue with npp in the mix even if i use an ai?

4. What is this whole prolactin sides thing with deca/npp?

Any other info people can give me is appreciated

 

[bigorse]

no eq? if you are doing npp just do 100eod of each and it will be plenty. shouldn't need to high of an ai dose as deca doesnt aromataise as much as test. take caber or prami throughout and run for 8-12 weeks

 

[Gboyt]

deca dick with the same npp and test dose wont be an issue? I'm actually leaning towards low dose test on cycles and let the steroids do the work but i've read to keep test higher than deca. i wanna put on 10-15lbs of lean mass before summer. In june im gunna play around with masteron a bit since i dont go bald (my dad is mid 50's on trt for 10+ years with a full head of hair, not even 1 grey) but i think npp would put more size on then eq, unless i run the eq from now until summer hahaha. clearly i have some studying to do because i was under the impression that deca aromatizes heavily, i thought this was the reason people get gyno and deca dick so often

 

[bigorse]

no deca is a 19nor steroid and increases progesterone and prolactin which is why you take caber with it. deca does aromataise but not as much as testosterone. 100eod day of each with prami/caber and low dose arimidex will be fine for most.

 

[Gboyt]

what is the purpose of the caber/prami

 

[bigorse]

what is the purpose of the caber/prami

keeps prolactin down, this will prevent prolactin gyno and milky tits as well as keep your sex drive from crashing with too much prolactin

 

[alphaasfuck]

What's a good dose of prami?

 

[bigorse]

0.1mg tapered up to 0.5mg ed. Taper slow! Sides can be bad!

 

[alphaasfuck]

I thought prami was supposed to be taken e3d, no?