Switching pins for ease of use/injection.

[gonelifting]

Pins and syringe for Test Enanthane (BL if it matters). How can I do it WITHOUT warming up the stuff? If I get 20 gauge to draw then switch to 23 gauge to inject. (I just read this from another post... sounds good) Will that work? If not I`ll go to 22 Will that work?

Also Is that 1 1/2 inch? (for glutes only)

 

[gilly6993]

that should work.....

 

[Dial_tone]

What matters is the type of oil in the juice. I use 23g for everything.

 

[jerkbox]

i draw and shoot with 23g.....same pin. I've done it without warming it up, just flows faster during drawing when warm. depends on the viscosity of the oil too, never used BL so I can't speak to that.

you could switch pins though like you said.

 

[jh1]

I use 23g to shoot and 18g to draw it up... has always worked for me.

 

[Flexx]

18 to draw and 22 to shoot.

 

[gonelifting]

Well why should I waste my time switching pins if I could use the same pin. I realise it`s slower to draw with 23, but is that all? How about contamination?

The less supplies the better for me. I already have a pharmacy on my kitchen counters. I`d rather have ONE box of pins. 23 it is... i think.

edit, How about the length 1 1/2? or "1" all the way in?

 

[jerkbox]

personally, i would rather not switch pins after drawing, just for fear of contamination, etc....plus it's kinda messy.

 

[02gixxersix]

I draw with a 21 guage just because I have like 500 of them and then shoot with a 23g. I use 1" 23g for everything. Drawing with a 23g sucks ass.I just draw the oil with the 21g then pull back on the plunger to get the oil out of the pin then switch pins and push the oil to the end.

 

[gonelifting]

Coin flip I guess... Everybody`s different. Thanks guys! I`m sure I`ll have an opinion after my first experience.