st8grad
New member
Bros, if you think your vials sterility has been compromised is there anyway to sterilize it. I baked my test e a couple days ago to remove ba after transfering it from satchets to a 50ml vial. When I was drawing today I noticed air bubbles going into the vial. It looks like the pin I used to vent the vial left a noticable hole in the stopper. I used as sterile of a procedure as I could in the transfer. But the air bubbles worry me now and so does the thought of something being introduced in the transfer. I did it this way because I didn't trust leaving gear in the syringe for use later. These satchets have become a royal pain in my ass, and literally a pain in my ass too. Can I filter the gear....bake it again....?? I need some help on this.

Please Scroll Down to See Forums Below 











