simple HCG question

[babbabuee]

coming off primo 200mg e3d with dbol at the front and back end of the cycle at lower doses 15-20. my last inject is next friday. my nuts are full in size and I can get wood if inspired.
I'm planning on running unleashed/post cycle/clomid/hcg.

but I'm not sure on how to run the HCG. How much and when should I hit the hcg?
thanks in advance.

 

[chordz]

The best use for HCG is to prevent shrinkage. You say there is no shrinkage, so you may not need it. If you are going to use it stop a couple weeks before PCT.

 

[Stillgoing]

2 ways to do it bro: 1- run while primo is still active so when you hit clomid your in full recovery mode (since HCG is thought to not allow recovery while your running it) or, 2- run after primo is out of your system as part of your PCT along with clomid etc. I've done it both ways and both worked. Also, on dosages, you can either run it 500iu ED for 10-14 days or 1000iu EOD for 2 weeks.
So:

Method #1: Start HCG approximately 2wks before you plan to start clomid. Run either 500iu ED or 1000iu EOD. Start clomid 3 days after last shot of HCG. You can hit it either IM or SQ.

Method #2: Start HCG same day you start clomid. Run either dosage schedule as per above.

 

[babbabuee]

since this would be my first time with hcg, do you think I could get away with 500iu eod?

also, I've got the 1500iu amps with the solvent. how do I mix them, and how can I save the unused portion?
any pain assoc with IM injects?
thanks for the info guys, karma to you both.

 

[Tuck]

While you're at it, how do you do IM injections? and where? do you have to aspirate? Thanks!

 

[Stillgoing]

since this would be my first time with hcg, do you think I could get away with 500iu eod?

also, I've got the 1500iu amps with the solvent. how do I mix them, and how can I save the unused portion?
any pain assoc with IM injects?
thanks for the info guys, karma to you both.

Well, first time's got nothing to do with it. Could you get away with it? Sure. Will it be as effective? I don't know.

You should have a sterile water vial and a powder vial. Simply shoot the water into the powder vial. Refrigerate the unused portion. Its only good for 30-60 days after reconstitution, so, be advised.

No pain with the IM's like you might get with prop, etc. I'd run SQ. Can't get easier than that. Go 27 gauge, 1/2 inch.

 

[Stillgoing]

While you're at it, how do you do IM injections? and where? do you have to aspirate? Thanks!

Hit IM injects anywhere you normally do, glutes, quads, delts. You always aspirate with everything when running IM.

 

[babbabuee]

can I put the liquid(small amp) in with the solid(large amp) and just stir it around with a needle(maybe just use an 18 just to stir it)? Otherwise, where would I get a sterile glass container?

 

[FinaGod]

I just mix it and pull it all into the syringe. I assume it's 1ml for 1500iu. If you want to use 500iu just shoot 1/3 cc and stick the syringe in the fridge. When you ready for another 500iu just change pins and you're good to go. Seems like less of a hassle like that. Anyone else do it this way ?

 

[NapoleanComplex]

here's where those tiny ass slin-pins come in handy. Damn that needle is small. Just pinch a little tummy-blubber and jab it in there...and squirt