Rubber in vial need Insructions please!!!

[bodybuilder63]

So i found a piece of rubber in the vial and im totally lost on how to get it out should i filter it? if so i need detailed instructions on how to do that. can i suck it out with a needle? Is my gear contaminated? i need help guys come thru with some solid info/ instructions!!!

 

[goin on 4T]

Either filter it and risk infection, don't know the probabily but it is a potential or just junk it.

 

[bodybuilder63]

fuck bro so i gotta waste that gear? thats gunna cut my cycle short

 

[burnthiscorpse]

Is it not a small piece of the stopper? If you use 18ga pins to draw with they will easily shear off small pieces of rubber on the way in the vial if your not really carefull. This is why i switched to 20 or 21ga pins to draw with. If thats what happened then dont worry about it. Just take care to avoid it when drawing. Once drawn, inspect your barrel in the light to make sure there is no foreign particles in it. I always inspect my barrels before putting them in myself.

 

[bodybuilder63]

i draw with a 21g and its a small piece of rubber

 

[Extra_Strong]

yes i agree with Burnthiscorpse .. i ordered some stealth couple years ago. I transferred all the stuff from packets to 50 mg vials.. doing so I used a 18g needle. and if i was not really careful piece of stopper would get caught in the hole of the needle..... i just made sure and kept my eye on it.. to avoid it going into my 23g pin.. but it was way smaller doubt stopper piece could of even been drawn up through it.

 

[bodybuilder63]

im still lost of what i should do guy should i try and filter it or avoid when drawing?

 

[HAYEZ]

Just filter it into a new sterile vial. Will cost you 7.00 from gpz. No reason to junk it. Push 2ml of grapeseed oil thru the filter at the end to flush the filter so you don't lose the 2ml of aas

 

[burnthiscorpse]

^^^^ if you want to be double safe then do as hayez suggested. I could see a 21g taking a piece of the stopper off too if your not careful. Some stoppers are way stronger than others. I too bought some gear that had to be transfered. The vials I bought had some pretty thin stoppers on them. Happened 3 goddamn times. Three chunks of rubber in one vial. Once I missed it drawing...upon inspecting my loaded barrel pre shooting i noticed the goddamn chunk of rubber. Thats why I say also again ALWAYS inspect your loaded barrel before shooting. You never know. If your in a room where the sun shines in, sunlight is the best light I have found to hold it up to for inspecting. It will make anything foreign stand out immediatley. Sometimes its more difficult to see things in a light bulb lit room.

 

[Extra_Strong]

Burnthiscorpse .. man when transferring i usually leave the needle in the stopper and detach the syringe instead of pulling it out and and restabbing over and over. keeps the rubber from wearing out as fast, also easier with the transferring of air over and over. plus don't have to use as many needles.

 

[burnthiscorpse]

Burnthiscorpse .. man when transferring i usually leave the needle in the stopper and detach the syringe instead of pulling it out and and restabbing over and over. keeps the rubber from wearing out as fast, also easier with the transferring of air over and over. plus don't have to use as many needles.

I was basically reffering to the vials I had ordered having thinner rubber on them just in general. Not to imply that I used multiple needles. However, that was the first and will definatley be the last time I buy gear that does not come in sealed vials.