Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

putting powder in solution

dr0832

New member
I heated up 151 and 65.5 ml. The powder seemed to be suspended at first but now I can see it again, its just not in clumps. Its a bit more uniform but I don;t wanna messed up and take 100mg of var instead of 15 X 2. So can someone tell should the solution be almost clear where I can see nothing at all or should i just skake it and take it? How long do you usually heat it. Just until the water boils or does it need to boil for 5 minutes or so before it will fully suspend?
 
In 151 it will not suspend. That's why I cap it.....best bet is to not let it set for too long as the powder will settle and clump at the bottom of the vial...you'll have to scrape it out.
beings that you did use 151....the stuff should evaporate under mild heat. Leaving you with all the powder in the vial.

Just weigh it afterwards to make sure what you actually have left.

I'd better add....never done var powder only drol.

Myth
 
Last edited:
Mythicalbeing said:
In 151 it will not suspend. That's why I cap it.....best bet is to not let it set for too long as the powder will settle and clump at the bottom of the vial...you'll have to scrape it out.
beings that you did use 151....the stuff should evaporate under mild heat. Leaving you with all the powder in the vial.

Just weigh it afterwards to make sure what you actually have left.

Myth


Nonsense. I use 151 to suspend most of my powders.
 
dr0832 said:
I heated up 151 and 65.5 ml. The powder seemed to be suspended at first but now I can see it again, its just not in clumps. Its a bit more uniform but I don;t wanna messed up and take 100mg of var instead of 15 X 2. So can someone tell should the solution be almost clear where I can see nothing at all or should i just skake it and take it? How long do you usually heat it. Just until the water boils or does it need to boil for 5 minutes or so before it will fully suspend?

What concentration are you using?
 
dr0832 said:
I did 15mg/ml. 1 gram of var in 65.5 ml


Just let us know how it goes. I'm curious to see if it crashes...and if you can just shake it or if it settles compltely...ect. I have yet to have one totally suspend.
 
Winny will only stay suspended for a day or two. Most have to reheat it EOD.

Even at concentrations of 20mg/ml, my var will stay in solution indefinitely after the initial heating.
 
Top Bottom