Pinning Question

[BLM Shot]

Yeah man, good place with good info here. It is greatly appreciated.

So the reason for pushing air into the vial is really only to make it easier to draw?

 

[Sherk]

^^^^Not exactly the only reason bro. By putting ml of air per ml of test takin your keeping the vial at atmospheric pressure, not a negative pressure. By doing so yes it makes drawing easier. If the vial gets a negative pressure inside it's going to want to pull the plunger in eventually making it impossible to draw.

 

[BLM Shot]

ok, good info.

Let's see if I can make this question make sense....So if someone was to put two oils in one pin (as in my question before), then would switching which vial you draw from create a good enough pressure or would that eventually catch up with you?

I guess to clarify myself. Should air be pushed into the vial every time someone draws?

 

[benchingover500]

Angelico, not sure what size u r using, but for oils, 23g works well.

 

[Angellico]

yes I am using 23g needles.

Now my needle is 3ml and im doing 2 250mg shots a week, Soo is 250mg = 1/4 1ml?

Looking on needle it goes 1/2, 1, 1 1/2, 2 all the way up to 3

I been looking on google and havent found my answer yet

 

[NOS2.0]

if it is 250mg/ml, then 250mg=1ml.
if it is say 300mg/ml, then 250mg=.83ml
if it is say 400mg/ml, then 250mg=.63ml
if it is say 100mg/ml, then 250mg=2.5ml
get the idea?
Dose you want divided by dosage on bottle = number of ml you should draw.

 

[Angellico]

for my shot im using 23g needles.

So I pulled back 1 ml of air aand relesedback into juice bottle, but when i try to extract juice it only takes some but mostly air.

Should i use bigger gage for extracting.

i did manage to finally extract what i needed . but i can see tiny little bubbles in needle, is that ok or do i need to extract again?