My first shot was a nightmare!

[mauit44]

I just spent 20 minuted drawing 2ML of Primo into the syringe, the 1ML of Test e was a bit easier however. I am using 23G and for draw and inject, but I know now that I'll need to get 22G pinz for the draw and possibly for the inject as well. I had a hard time injecting as well, and found myself using both hands to squeeeze the syringe! Is 22G good enough for draw and inject? Or should I go to a different size?

 

[mattrich]

i use 18g to draw(pink pins) and 23 to inject no probs at all never tried primo though.

 

[SgtSlaughter]

18 or 20 to draw.

23-25 to inject.

 

[mauit44]

18 or 20 to draw.

23-25 to inject.

It took forever with a 23G pin, I can't even imagine using a 25G. Primo is some thick stuff.

 

[lifthard2005]

i use 18g to draw(pink pins) and 23 to inject no probs at all never tried primo though.

DITTO!

 

[mauit44]

DITTO!

Primo seems to be thicker than Test, Sust, or Deca.

 

[SwolK]

warm the vials up a little bit with a hairdryer. it will flow easier.

i draw with 23ga and inject with 25ga with not problems

 

[NaturalOnlyAtBirth]

I've begun to use only 20g to draw, overtime with 18g on the larger vials, repeated drawings tears the rubber stopper up.

 

[mauit44]

warm the vials up a little bit with a hairdryer. it will flow easier.

i draw with 23ga and inject with 25ga with not problems

Thanks bro, I'll do that! The 23g wasn't bad at all to inject with.

 

[Ralkoh]

I use 22 to inject works fine for me

 

[UFC22]

wow those oils must be thick! Warm up the vials like stated above and that should make it alot easier.

-20 to draw and 25 to shoot-

 

[black sheep]

I inject 200mg/ml Primo with 25g and draw with 22. It flows just fine. I am not sure what you are using, but next time I would pick a different product line.