Multi-roid syringe

[HiGear]

What is the safest procedure for using one syringe to inject two or more steroids?

 

[MUSTANG_18]

Get an 18G drawing pin and draw out the desired amount of AAS from the Vials, switch the pin, get out all the air, inject and grow

M18

 

[HiGear]

What is AAS?

Also, is there no need to switch pins before drawing the second steroid? Would not switching pins decrease sterility or cause mixing in the vials?

 

[MUSTANG_18]

What is AAS?

Also, is there no need to switch pins before drawing the second steroid? Would not switching pins decrease sterility or cause mixing in the vials?

AAS = Anabolic/Androgenic Steroids
As for your second question, When mixing 2 diffrent compunds in the same syringe I have never switched drawing pins and have not had a problem, it's not neccesary IMO

M18

 

[gilly6993]

AAS = Anabolic/Androgenic Steroids
As for your second question, When mixing 2 diffrent compunds in the same syringe I have never switched drawing pins and have not had a problem, it's not neccesary IMO

M18

.....yep, I also use the same needle for drawing multiple compounds

 

[jc21]

yep me too

 

[freakazoid]

me three,i have even put sust,and winney in the same syringe.oil and water wont mix,but there is really no reason to use two different syringes.

 

[jc21]

yep i have done oil and water together with no problem.

 

[LftHndPwrHouse]

Are there somethings you cant mix? Or can you mix just about everything

 

[freakazoid]

you can mix any a.a.s. i have never heard of mixing h.g.c,or g.h,or insulin with a.a.s so i would not try thoese.

 

[Wrongun]

I always draw with one pin then swap and shoot all as M18 said.

I mix all with max of 4ml in one hit. Works well and no need to keep swapping. Really helps when using many ED jabs

Wrongun!

 

[JG1]

When ever I load two or more steroids in a syringe, I always load each compund in it's OWN syringe first. I don't like to cross contaminate the vials. I then pull the pin off of one of the syringes, and inject the other gear into that syringe.

Probably not necessary, but like I said, don't like cross contaminating the gear.

 

[Wrongun]

When ever I load two or more steroids in a syringe, I always load each compund in it's OWN syringe first. I don't like to cross contaminate the vials. I then pull the pin off of one of the syringes, and inject the other gear into that syringe.

Probably not necessary, but like I said, don't like cross contaminating the gear.

Agreed but i do it not so much for contamnination protection (as all will be mixed together anyway LOL) but simply easier to get accurate measurements of each med for accurate dosaging

Wrongun!