Please Scroll Down to See Forums Below
Little rubber floaties in juice.....
- Thread starter Diesel3d
- Start date
C
Code
Guest
A syringe filter is a little filter that rests between the syringe and the needle.
Very handy indeed.
BD sells them.
Very handy indeed.
BD sells them.
Diesel3d
New member
the thing is with using a filter just for injecting you might not even get any of the juice out. I wanted to filter some juice i had... i pumped 3 cc's into the filter and it absorbed it all.
In the end i had lost a few ccs even after i tried purging it with air. Those things are amazing.
In the end i had lost a few ccs even after i tried purging it with air. Those things are amazing.
solidspine
New member
Don't use the same needle to draw, each time, and don't worry about injecting rubber in your body, just be careful.
You could finish that vial drawing with a smaller needle to minimize sucking up the rubber,
you maybe received old vials and the stoppers dried out.
You could finish that vial drawing with a smaller needle to minimize sucking up the rubber,
you maybe received old vials and the stoppers dried out.
Diesel3d
New member
solidspine said:
hmm well before i put on a new drawing needle and draw i wipe the top of the vial with alcohol to kill any germs that may have gotten on it from being in my pocket on the way to the bathroom or from where i store it.
That must be it. It must be drying out the rubber. dried + 20g drawing needle must be the problem..
Thanks
YESSS!!!!!!!!
I did this once.
I drew a few ccs of deca and an omna cc into my 25gauge.
Then I gave it to my friend to stick for me (this was during the time when I was too chicken to stab myself, hehe). So my friend stabs me, and then about 1/4 went in and then all of a sudden it became increasingly difficult to push the rest through the pin...
Next thing I knew it was like 5 minutes later and my friends hand was turning blue. To make a long story short, the way I found out some of the rubber stopper had gotten into the pin was when I cleaned it with alcohol after. I poured some alcohol into it and tried pushing that out.. when the alcohol wouldnt even squirt through I pushed real hard over the trash can and then the tiny rubber particle shot out like a fucking bullet!
Good thing that shit didnt end up shooting into my ass cheek at lighting speed. God knows what would have happened..
DOCV
I did this once.
I drew a few ccs of deca and an omna cc into my 25gauge.
Then I gave it to my friend to stick for me (this was during the time when I was too chicken to stab myself, hehe). So my friend stabs me, and then about 1/4 went in and then all of a sudden it became increasingly difficult to push the rest through the pin...
Next thing I knew it was like 5 minutes later and my friends hand was turning blue. To make a long story short, the way I found out some of the rubber stopper had gotten into the pin was when I cleaned it with alcohol after. I poured some alcohol into it and tried pushing that out.. when the alcohol wouldnt even squirt through I pushed real hard over the trash can and then the tiny rubber particle shot out like a fucking bullet!
Good thing that shit didnt end up shooting into my ass cheek at lighting speed. God knows what would have happened..
DOCV
Solidspine hit it right on the head.
Use a new pin everytime you draw or inject. Besides, even drawing will dull your needle a little. Minimize your scar tissue too by changing to a new one, especially if you're using big pins (20-23 ga.)
Some people spend HUNDREDS of dollars on a cycle, but when it comes down to it, are hesitant to spend a couple of dollars on shooting it the safe, correct way. Be smart. Not trying to flame anybody, just something to think about.
Use a new pin everytime you draw or inject. Besides, even drawing will dull your needle a little. Minimize your scar tissue too by changing to a new one, especially if you're using big pins (20-23 ga.)
Some people spend HUNDREDS of dollars on a cycle, but when it comes down to it, are hesitant to spend a couple of dollars on shooting it the safe, correct way. Be smart. Not trying to flame anybody, just something to think about.
