Liquid Exemestane & Liquid Clomid

[Seth]

Liquid Exemestane & Liquid Clomid

I got some Liquid Exemestane, and I know it is supposed to be suspended in water, but there are lots of what look like clear crystals floating in it. I have been trying to draw it out with a 25ga. syringe to put it in caps, but it won’t suck the floaters up.
That is the only size pin I have – any ideas how to measure it and get it into an empty cap??

I also have some Clomid that I bought when I did my last cycle (August of 2002). I didn’t need it (had some tabs left over). Now it is all dried to the inside of the bottle – but the liquid it still there. It is almost impossible to see into the bottle below the liquid line, that’s how much is stuck to the glass. I tried to shake it and ran it under hot water, but nothing has seemed to work. This has never been opened. Am I going to have to open the vial and try to scrape the junk off to get it to dissolve again? I am assuming that there isn’t any expiration date and that this should still be good.

Thanks for any help.

 

[TrueCowboy]

Listen, all you have to do is heat both vials in water . Take a pot of water, place a saucer at the bottom to seperate the vial from the hot bottom, and heat the water for a few minutes with vials in it. It is no big deal. Nothing is wrong with your stuff. also, you might want to stick a needle in each vial to let any air pressure off when it gets hot.

 

[granby140]

listen to cowboy my clomid was a solid chunk of white powder. It def worked

 

[Zyglamail]

And people wonder why I preferre tabs, liquid is a pain in the ass.

 

[tbro]

absolutely Zyg......