Karachi Sustanons...

[satchboogie]

cheaper than turkish but good quality...

 

[The Terminator]

Good stuff

 

[Sta11ion]

Gets you hard, and filled in.

 

[SanFrancisco]

I have a really stupid question as i have never used these small vials . how does one access the juice when it's in a self contained tiny vial such as that. My only experience is w/large vials with a rubber stopper.

(i should probably kno wthis)

 

[Big BX]

I have a really stupid question as i have never used these small vials . how does one access the juice when it's in a self contained tiny vial such as that. My only experience is w/large vials with a rubber stopper.

(i should probably kno wthis)

You pop the top then stick the needle in. Then draw, it's the same as drawing from a vial.

 

[scartissue]

I always use a different and larger needle to draw the oil out, then switch to use the pin I am injecting with

 

[Distortion]

Those are the ones I had, good stuff.

 

[foozrrr]

Get a vial scorer, scores the top, snap it off, enjoy!

 

[BigJoshRn]

I always use a different and larger needle to draw the oil out, then switch to use the pin I am injecting with

Amps aren't too bad once you get the hang of it.
1. Twirl or thump the fluid out of the top of the vial.
2. apply a hard object (thumb, syringe, pen with cap on...etc) at the area where the top meets the amp...this area is usually scored to help open it (If not you will need an amp scorer). If just using your fingers you can also cover scored area with something to protect your them...I will wrap an alcohol pad wrapper around the top of the amp, then break.
3. It is advisable to use filtered needles to withdraw from the amp as there is a small possibilty that you can aspirate small microscopic shards of glass. I know this is improbable, but better safe than sorry...especially if you can get the filtered needles.
4. If you are not using a filtered needle, I always hold the syringe up to the light and make sure there is no glass in the syringe.
5. Change needles and inject.
Hope this helps...BigJosh

 

[musketeer]

Use a pencap to break open the amp. Simple but effective.