Just finished my 150mg/ml Masteron homebrew

[psychedout]

nah, bb is painless. ba, well...



BTW, ive never got var to go into solution any higher than about 10 mg/ml in everclear.

This is a common misconception. BB can and will cause pain in 15-20% and higher concentrations. The factor determining this is really individual tolerance.

Trust me on this. I one had the idea to create a solution using 50% bb to make is very thin so it would flow easily through a slin pin. And well, it did do that, but holy fuck did it leave some nasty pain after. That went down the drain -- big waste of cash.

 

[SlimJim300]

Congrats, I have some Masteron powder as well to convert. Are you running the Var with it?

I use about 10cc peg 400 with the rest everclear to hold my 10mg/ml var it does good just does not completely dissolve but almost.

Yes I'll be running the var with it. How many mls total solution did you make for that?

 

[lurcan]

I ususally use 150mg a day of mast, 100mg of mast e and 50 mg of mast p. I'v hade no problems and it's ripped me up pretty good. Granted I use a lot of gear to protect my hair, which is not falling out, even if I use it with Winny d(Test is a given, I never do cycle without it) and Tren. I swear I'm not bullshittinng you. One day I'll post pix of the hair both before and after.

 

[glover]

Yes I'll be running the var with it. How many mls total solution did you make for that?

Sorry for the lack of details. I use 10 mls PEG 400 and 39 mls Everclear for 50 mls of 20mg/ml Var. Not the 10 mg/ml I stated earlier that was incorrect. Stays in solution pretty good. But after cooking I can never get 100% crystal disolve, probably 85-90%.

 

[SlimJim300]

Thanks glover, good info. Can you get it to hold at 20mg/ml when you use the PEG, or does it fall out of both the solutions you made?