I just gave myself an injection of EQ and could hardly push it through. It was a normal 23g 1 1/2 inch needle. I have never had trouble with this before. What could be going on?
I use a fresh pin for drawing it,and a fresh pin for injection
try heating the Eq up bro,by setting the bottle in really hot water for a few minutes that will thin it out considerably and make the injection process much easier for you.
I just gave myself an injection of Equipoise - boldenone undecylenate - and could hardly push it through. It was a normal 23g 1 1/2 inch needle. I have never had trouble with this before. What could be going on?
you may have hit some scar tissue, or the gear could have been a little cold, next time warm the gear after you put it into the syringe under hot water before you try injecting it. YOu don't want to inject the gear fast anyways, the slower the injection, the less likely you are going to get a knot, or experience pain from the injection site.
Kidding? No! if you read my statement i mention the syringe not the pin, i always use 2 pins for every inject one to draw it and a fresh one for the shot.
I bet I did hit scar tissue I had given myself a shot recently in same spot. I didn't know that could make it that hard to push the oil in. My quad is a little sore and swollen today. I've never gotten that from this stuff before. Could that mean anything bad?
I bet I did hit scar tissue I had given myself a shot recently in same spot. I didn't know that could make it that hard to push the oil in. My quad is a little sore and swollen today. I've never gotten that from this stuff before. Could that mean anything bad?