injection Q

[kmoe42]

ok.. with a 1.5 inch pin and 22 gauge.... i will be injecting test E, deca, and winstrol.. my question is whenever u inject can u go to deep into the muscle like sticking the needle in to far or is it ok if u do that.. i will be injection glutes,traps,bis, and quads so i dunno if it is a problem if u push the pin in to deep when u inject or not?

thanks

 

[tiggerizme]

1.5 in the glutes I don't think you'll have a problem with going to deep. You got the right size and length of pin for that injection. You shouldn't have any problems at all.

 

[factory46]

1.5" is pretty safe, but it varies on the injection spot. Obviously the glutes are the easiest. You have to use a little judgment based on how much fat is under your skin. 1/2" to 1" is good for arms and traps. If you hit the bone (unlikely), you'll feel it and pull out.

Check out this site, its good:

http://www.howtodoinjections.com/im.html

 

[letsrun4it]

Dont use a 22g man, you can fit all that gear through much smaller. 25g would work fine.

 

[plifter48]

Yeah, try to use the smallest size pin you can to minimize scar tissue. A 1" 25 gauge works everywhere for me.

 

[rick_hfh]

Agreed, I was injecting 22g 1.5" all the way in. There is a bit of pain. After switching to 25g 1" there is far far less. Very slight soreness the next day.

 

[Cauliflower Ear]

yeah...i have 22gauge at 1.5 inches...it is really sore the next day...the next batch of needles i will get 25 gauge...but i like the length

 

[BigCracker]

Dont use a 22g man, you can fit all that gear through much smaller. 25g would work fine.

V used to clog up in smaller pins for me, so I prefer a larger gauge like 22. It takes a lot less time to squeeze it all in too.

 

[factory46]

IMO the slower in, the better.