Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Injection length?

Pat Mycroch

New member
How long should a typical injection of say 2cc of sust last. I know that if you go too fast it won't be absorbed properly, and if you go too slow it isn't really neccasry, but what would be an exact time?
 
I am a newbee but I did read about what you are refering to. The post I saw was about beening sore and it said to make the injection last for about 20sec or as slow as posible It said it would cause less tissue damage and also the absortion would be quicker because the chemicals would not be in a large lump but would spread out a little more. Also I would think that it would depend on the needle size, smaller the needle the more the presure of the substance would be leaveing the needle. I don't think that it would have that much actual effect on the long term effect of the substance being injected just the disdrabution of the substance at the inject site, and might allow a little quicker breakdown into the body.
 
Reduction of pain and inflammation is not associated with how long a pin is in the muscle, but the consistency of the oil itself. The slower you introduce the oil containing steroidal matter into a muscle, the easier it will be for your system to absorb and internalize it. Warm up your sus to near body temperature, and take it nice and slow...don't forget to aspirate.
 
Use sterile technique, Aspirate and simply inject firmly not fast, be steady, but 2cc should go in in less than 45 seconds quite easily.

If you force it, yes it will hurt more but also, more can back out when you remove the needle.
 
It takes me about a minute to inject 2cc of Sust and Eq. I like to put a little pressure on the plunger but not force it and go to fast(The needle moves to much) Good Luck!

M18
 
Top Bottom