Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

injecting skinny legs

  • Thread starter Thread starter leonidas33
  • Start date Start date
leonidas33 said:
would it be ok to inject quads with an insulin pin (200mg test enanthate), if you have pretty skinny legs... it just seems that the muscle is just right there and not a lot of fat covers it...


you will never get that to pass thru a insulin pin.
 
ALIN said:
you will never get that to pass thru a insulin pin.

can't speak for TE.ST E

actually the only two I can attest doing this with is TR.EN A & PR.OP

...currently using 25g, but it's a 3cc, not a insulin
 
THE GOOD SUN said:
can't speak for TE.ST E

actually the only two I can attest doing this with is TR.EN A & PR.OP

...currently using 25g, but it's a 3cc, not a insulin


I got 75mg of te.st e to pass through ok yesterday!
 
bluetwistedsteel67 said:
if you have skinny legs you shouldn't be juicing. gear is for people that can't grow any more than they already have naturally

ha! otay! :p
 
Powerbuilder333 said:
Back filling a insulin pin? When you put the plunger back in, how do you keep the gear from squirting out?

keep it held with needle pointed up and the juice against the plunger... the air is ejected first...
 
leonidas33 said:
keep it held with needle pointed up and the juice against the plunger... the air is ejected first...
Then what keeps the gear from running out the back? At some point you have to push the plunger in to get it seal, which would squirt it out the front if it's pointed down, or it'll drip out the back if it's pointed up - right before it's sealed.
I quess I'll just have to expeirment with some low cost juice.
 
Top Bottom