Please Scroll Down to See Forums Below
napsgear
genezapharmateuticals
domestic-supply
puritysourcelabs
UGL OZ
UGFREAK
napsgeargenezapharmateuticals domestic-supplypuritysourcelabsUGL OZUGFREAK

Injecting - here is my step by step plan...

Steve The Bluesman said:
1st injection cycle starts in 10 days. I have no fear if all goes right, and thought I would throw this out there for crticism.

Here are the steps I plan on taking - please add/modify anything that may be off:

1. take a shower
2. wash hands
3. alcohol swab the injection spot
4. heat up the amp (I plan on running under the hot tap for a couple of minutes.)
5. open the amp (I am going to score lightly with an exacto knife, and use the top of a bic pen to snap the neck off method.)
6. draw with a fresh 20g
7. switch to a fresh 23g
8. flick the air out of the syringe
9. squeeze a drop of oil out of the pin for lubrication
10. stick (don't fuck around about it - in it goes like a dart, top outside quadrant of the ass.)
11. aspirate
12. inject slowly, pin as still as possible.
13. alcohol swab
14. massage ass for a few minutes, possibly sit on heating pad for 15 minutes.
15. go lift.

What do you think? :)


Bluesman


Alcohol swab to site is plenty clean unless you have real issues.
No need to heat the amp, i\I never have and have had no problem.
Air in syringe will not, i repeat, will not hurt you, can help prevent leak and bleeding.
No lube needed, you did say fresh 23g.
Slowly, no other option with 23g.

Good luck
 
save a few steps by placing the needle pointing up on top of a heating pad then just sit down

on a serious not i think its all the right steps once you get used to it im sure youll cut a few out, good luck
 
Last edited:
Even though I go over the steps in my head every time I do it, I have still missed step 7 on occasion, and that just sucks.
 
Top Bottom