In-situ removal of benzyl alcohol.

[Andy13]

I would really like someone to try this... It's totally easy to do...

Get at least a 5cc syringe. To 1ml of your T-400 (or whatever) solution, add 1ml of sterile oil or a lower concentrated AAS such as 50mg/ml EQ. This extra oil is added to prevent the steroid from precipitating (dropping out as a solid)

Add 1ml of sterile water to the syringe and pull the plunger down so that there is some empty space in the syringe. Mix thoroughly by shaking for at least 30 seconds. Allow layers to separate, invert the pin so that it points down and push the water out.

The BA will be taken out with the water.

Andy

 

[Andy13]

 

[Big Johnson]

Very nice, Andy.

 

[Andy13]

I really wish someone would try this...

 

[Laserdude]

You are most likely to find that someone will try it.

Sounds like a great idea.

Good post. Sterile Water only out of a distiller will do fine.

 

[liftsiron]

Have you tried this?

 

[Andy13]

Well, I don't have any gear with a high enough amount of BA..

I mean, don't get me wrong.. I know it will work.. That's because BA has water solubility, and when exposed to water, BA would rather hold hands with the water than the oil. The oppisite is true for the steroid... It will not come out of the oil.. It is FAR more soluble in the oil than the water.

Andy

 

[CYCLEON]

might start looking at doing that whole batch with my next chinaman jug

 

[Mike21]

sounds like a VERY good idea bro - good post

 

[liftsiron]

I was just wondering if you had tried it, I can't think of any reason that it wouldn't work. Good post.