Steps for a perfect injection:
1) swab the bottle top with a fresh alky pad.
2) swab the injection site about 2 inches to 3 inches with another fresh alky pad.
3) after needle pull-out, swab the injection site immediately then put pressure on the
the injection site with cotton / toilet paper to avoid bruising for 30 seconds.
4) swab the bottle top again with a new alky pad.
- you're good to go. I usually lean up against the wall with a bundle of toilet paper pressing against my injection area. I love injecting my shoulders - and have done so soley since using gear. I really hate getting bruises there - so pressure is a must, and remember your favorite spot!
Also, here's something else to think about. I've used high dosed testosterone compounds in the past like 400 enth/cyp test and my whole arm would swell up, get hot and turn red. I know the compound wasn't dirty, it was my body not being used to the high dosings..and I know a lot of bro's who can't handle the 400mg shots.. Not, 2 ccs of 200 mgs, the kind that comes dosed at 10ml/400mg..
Also, I had just the nastiest sides from Boldenone Prop..OMG..that stuff is the father of all painful injections..and I couldn't work out for weeks..never again!