How fast do you inject?

[DjKolxoznik]

Hey guys! Just wondering, how long does it take youto make an injection? Do you do it slowly? Just how slowly? I haveclocked my injection, and it lasts approximately 15-20 seconds for a5 ml vial. What about you? Opinions?

 

[gorillahung]

If I'm injecting 2 CCs then it takes 5-10 seconds for underground lab stuff because it's usually thicker than pharm grade.

 

[tyler_797]

Damn. I typically take 3 minutes to do 3ml with a 23g pin. Even then sometimes i can feel pressure and slow down a bit. I heat it up under the tap as well so it's going in warm too.

Sent from my SM-G925W8 using Tapatalk

 

[Zinergy]

I never force it in, just some light pressure to get it going. takes 1-2 minutes depending on how much oil.

 

[stevesmi]

i want to get it over with but squeezing thick oil through a needle takes time

plus your muscle appreciates a slow approach.

 

[gorillahung]

For you guys taking minutes, what gauge needle are you using? I'm using a 22G with a 1" pin.

 

[Lev Butlerov]

I usually take it slow, and it would take me like 45 seconds for one injection. However, ever since I have switched to Berd's gear, it takes no more than 30 secs, because their gear is so smooth.

 

[Zinergy]

I usually always use 25gauge 1".

 

[MasonicBodybuilder]

I use a 23g needle and it probably takes me 10-20 seconds to inject 2-3cc.