help loading syringe

[Hoover]

Hey guys, I bought a jug of eq and transferred it into a vial. Well, I just went to load my first shot and when I put the need inside the vial, the plunger shoots all the way up to the top. If it does not shoot all the way up to the top in the beginning, it does right after I am done loading 1 cc and remove it from the vial. What the hell can I do to prevent this from happening? Please help ASAP, I need to take this shot.

 

[trial0r]

you dont have equal pressure in the container so the air is diffusing from where it is dense to where it is less dense.

 

[Hoover]

k so what can I do from stopping this?

 

[pump it]

did u take any air out of the vial before putting in the eq??

if not, then youve got ten ml too much air in there. try pulling some out and your needle should work fine.

 

[XBiker]

You need to equalize the pressure in the vial.

If you filled the vial and did not vent it while filling, there is a high pressure concentration in the vial.

Take a pin from a syringe and stick it in the top of the vial. That will equalize the pressure.

 

[Hoover]

thanks pumpit, i just had sucess doing it

 

[Rotty]

Whats up Hoover..