Heating the oils?

[The Alpha...]

New cycle going (OLM300) hybrid from syntrop that contains 100mg ea of test prop, NPP and masteron per ml. It's pretty brutal and painful. Lab recommends heating the oil up pre-injection to allow the esters to bind otherwise they just crystallize in the muscles and can bring on cellulitis. Is this common with anyone else. Any other recommendations?

 

[The Alpha...]

30yrs old 5'11 240 lbs about 10%. Usually run test P, Npp and masteron by themselves (100mg each eod) but decided to go this route with them already combined... Just trying to continuously add lean muscle. I run this cycle for about 3 months at a time...

 

[ConanX]

I heat the oil up most of the time before I pin. I do something really simple. I just run hot water and put the syringe under the hot water from the sink. In about 2 minutes the oil should be warm.

 

[The Alpha...]

I've never really had to heat em up until now with this OLM. If I don't then I can expect a softball sized hot red knot for about 7-10 days. Warming it up cuts it down to about 4 days and half the size knot without redness or heat.

 

[Arabian]

I heat the oil up most of the time before I pin. I do something really simple. I just run hot water and put the syringe under the hot water from the sink. In about 2 minutes the oil should be warm.

^^^ ConanX is dead on. I have done this under hot tap water for years. I find it helps tremendously

 

[gwilym]

I put my vial in a glass of warm water to heat up while in showering and it's ready when I step out...was using t400 and didn't heat it a couple of times and ouch sitting was difficult for about a week...the one thing that did help was the heated seats in the car

 

[ALIN]

New cycle going (OLM300) hybrid from syntrop that contains 100mg ea of test prop, NPP and masteron per ml. It's pretty brutal and painful. Lab recommends heating the oil up pre-injection to allow the esters to bind otherwise they just crystallize in the muscles and can bring on cellulitis. Is this common with anyone else. Any other recommendations?

Some do this to help the oil pass through the pin easier,,some say it cuts pain down too if you have any.

 

[The Alpha...]

See that's what's odd to me, I've heard of people heating them up for the flo, but I was told for this product to heat it up to allow the esters to bind otherwise they will just crystallize in the muscle. That part is what is new to me. Anyone heard of this before? Any suggestions as to why this gear is so damn painful? Over dosed, too potent?? I'm lost... Never had this problem with almost 8 yrs of experience...

 

[gymrat827]

tes p, mast and npp are all very short esters....they are going to hurt. also its mg per ml is prolly higher than what you are use to.

you could also cut it with sterile grape seed oil or sterile Emu oil.