Good to the last drop?

[the small soldier]

My friend just started a cycle yesterday and he is terrified of needles. he had the little snap top vials of Cidoteston and asked me to shoot him. I did his shot and it went fine, but i was unable to get all of the oil out of the vial there were a few drops..maybe .1 ml left behind. Is that normal it was a 1ml 250 mg vial

 

[Cardinal Slin]

Well, it is some how normal but at the end of the day, no matter which way you look at it, you just wasted 0.1ml or 10 per cent of what he spent his hard earned bucks on.

If you want, buy a 21g needle, make sure you suck up (no mo) every last 0.1ml) then change it over to a 23g and shoot.

 

[the small soldier]

well if it doesn't all get sucked up how many times can i just try to keep releasing and re-pulling? does it even matter?

 

[Cardinal Slin]

Nope, it doesnt really matter, you can continue doing it until you get tired of it or until the amp/vial is all clear and everything has been sucked in to the syringe.

If you use a 21g or even a 23g needle, you can usually have it all in the syring within 30 seconds to a minute.

Good luck with your cycle.

 

[the small soldier]

Nope, it doesnt really matter, you can continue doing it until you get tired of it or until the amp/vial is all clear and everything has been sucked in to the syringe.

If you use a 21g or even a 23g needle, you can usually have it all in the syring within 30 seconds to a minute.

Good luck with your cycle.

aight thanks a lot

 

[HAYEZ]

your losing .10 in the amp,plus your losing .10 in the barrel of the needle...so out of your ml you think your getting ,your say dosed at 250 per ml your only getting 200mg per shot...find a better technique in drawing..lot to waste!

 

[the small soldier]

how do you do it?

 

[ALIN]

My friend just started a cycle yesterday and he is terrified of needles. he had the little snap top vials of Cidoteston and asked me to shoot him. I did his shot and it went fine, but i was unable to get all of the oil out of the vial there were a few drops..maybe .1 ml left behind. Is that normal it was a 1ml 250 mg vial

If you try real hard you should be able to empty the vial totally.

 

[HAYEZ]

how do you do it?

you could take bit of sterile oil and put some in the amp,then draw that up to get the rest out or draw it up with a 25 gauge pin,takes longer but its a smaller gauge may get more suction for the little amount of oil...adding sterile oil it will dilute the oil in the pin itself so when you do lose the .10 in the barrel its minimized...

 

[eddymerckx]

your losing .10 in the amp,plus your losing .10 in the barrel of the needle...so out of your ml you think your getting ,your say dosed at 250 per ml your only getting 200mg per shot...find a better technique in drawing..lot to waste!

and the gear is prob 150-160 of the 200 --depending on the ester etc--

 

[HAYEZ]

and the gear is prob 150-160 of the 200 --depending on the ester etc--

i know most people really dont care about consistency...but i have a problem with doses and injections being exactly correct and at the same time...lmao...my last shot out of each vial i get that last little drop...lmao..if i want to inject a certain amount and i paid for it,damnit i want all that shit in my blood...lolol

 

[eddymerckx]

i know most people really dont care about consistency...but i have a problem with doses and injections being exactly correct and at the same time...lmao...my last shot out of each vial i get that last little drop...lmao..if i want to inject a certain amount and i paid for it,damnit i want all that shit in my blood...lolol

oh i do to--even though i know it really does not matter and consistency and correct dose it really the proper way to do it anyway.

 

[halfcenturian]

I hate amps! I don't care if it's magic Dick grower. They are a pain in the ass.

Gimme the Made in the USA, Prescription, Human Grade Test. Properly dosed, sterile and painless.

 

[Big_Joe]

The best way to draw from an amp is to use a blunt. But nobody sells blunt needles.

And I really doubt that there was one tenth of an ml left in the amp. more like .01 not .1.

 

[needtogetaas]

Get all that shit bro. Ever last drop.

 

[the small soldier]

Im going to be giving him another shot in a few days So i'm going to just pull and pull until I get every drop. I"m getting more pins tomorrow and hopefully the bac stat water will be here in 2 days. If all goes well i start my cycle 2 mondays from today

 

[Cardinal Slin]

You do not need to go over the top with bac water to ensure you are injecting everything - that is taking things a bit too far.

 

[blooddrinker69]

If you have a little left over then just pour it in your eyes. I had one of those vials and I was trying to snap the top off when I squaesed to hard and it exploded on my face. Some got in me eye. It is invigorating.

 

[Burpees]

If you have a little left over then just pour it in your eyes. I had one of those vials and I was trying to snap the top off when I squaesed to hard and it exploded on my face. Some got in me eye. It is invigorating.

lol I thought you were being serious.. im like, wtf..what about the glass? heh.. then i read the rest of it.. I read fast, but my brain thinks faster.

 

[ironcheif1984]

your losing .10 in the amp,plus your losing .10 in the barrel of the needle...so out of your ml you think your getting ,your say dosed at 250 per ml your only getting 200mg per shot...find a better technique in drawing..lot to waste!

You can also avoid this too if you want to. You just have to draw up a little bit of air into the syringe before you draw up the oil once you draw up the oil make sure the bubble goes to the top when the needle is pointed towards the floor so when you shoot in the air bubble will push all of the Test or what ever you are using out of the syringe and will waste little to none this way.

 

[HAYEZ]

You can also avoid this too if you want to. You just have to draw up a little bit of air into the syringe before you draw up the oil once you draw up the oil make sure the bubble goes to the top when the needle is pointed towards the floor so when you shoot in the air bubble will push all of the Test or what ever you are using out of the syringe and will waste little to none this way.

i have tried to inject a few times now with a air bubble in the top...but i cant get it to aspirate when i do so???are you able to aspirate

 

[ironcheif1984]

i have tried to inject a few times now with a air bubble in the top...but i cant get it to aspirate when i do so???are you able to aspirate

Yeah i have no problems with aspirateing it at all i dont know how you would.