First inject cycle help - Test P

[judasprius]

Yeah, 18 is great for drawing. I just had an experience where it started leaking through the holes when I went to draw, so I stopped using the 18ga.

 

[shirlene29]

you can backload syringes too but I think this is sloppy for possible infection and tons of air

it probably would be no beuno in the doses youre looking for but I have success with test prop drawing and injecting with a 29g slin pin...but Im goin for an obv way smaller dose and subq injection

I just put it under hot water first and its smooth like butter in about a minute

 

[Jamesm11]

you can backload syringes too but I think this is sloppy for possible infection and tons of air

it probably would be no beuno in the doses youre looking for but I have success with test prop drawing and injecting with a 29g slin pin...but Im goin for an obv way smaller dose and subq injection

I just put it under hot water first and its smooth like butter in about a minute

Thanks for the recommendation. I forgot about warming the test first. Would I just put the syringe in after I draw it or just put the vial in each time?

 

[shirlene29]

put the vial in and warm it up...it will stay warm and more fluid for a while

like I said...its not a huge deal if you take your time

 

[Soadman]

you can run prop if you want, just be prepared to have some pain...

if you run test e, the cycle will be longer... arimidex will help with the bloat...

otherwise as i said, your pct needed fixed... i posted a much better pct

Dylan I had absalutely no pain with prop so that's not always the case here! I love prop by far the best ester .