Please Scroll Down to See Forums Below I just tried to process some finaplix-h for the first time. After I dissolved all the pellets (took about an hour), I mixed in the second solution and the poured this into the two coffee filters and let sit overnight. Well, only about half went through the filters. I let it sit for a while more but there was no way the rest was going through the filters. Two questions.....1) What can I do with the stuff (about half of total solution) that didn't go through the filter? 2) Is the stuff that made it through good? It smells like alcohol.
fina making problem
- Thread starter tbod1
- Start date
If you used an A kit, coffee filtering is not necessary and actually a big hassle and a waste of time. At this point if you still have oil in the coffee filter, you need to pull the open end together and twist slowly to force the fluid through. Be carefull, too much preasure can rupture the coffee filter. Have you heated the mixture at all yet?
It was an SD kit, but I have heard people say that the coffee filtering was an unecessary step unless the solution oxidized. What I did then was mixed everything (coffee-filtered stuff and non coffee-filtered stuff) back together. Then I tried to run it through the syringe filter and got about half of it through before it clogged up which I sorta figured was gonna happen. Is there anything I can do now? Is the stuff that made it through good fina?
I cant vouch for the SD kit, but you seemed to have missed a very vital step in the process. After disolving the tren in the magic solution, it should fully dissolve. AT this point it will be suspended in the magic and STAY THERE!. Now, add oil swirls to mix and heat in water that has been boiled on stove and removed from the burner. This heating process is vital since it causes the gunk thats in the pellets to stick together and fall our of suspension where it will settle on the bottom of the vial. Let sit for a few hour and allow gunk to settle and then reheat, but only slightly so solution is warm and flows through the sterile filter easier. Then carefully draw out solution, avoiding the crap on the bottom. Remember ITS NOT TREN, the tren is and always has been suspended in the liquid protion since it was dissolved in the magic solution.
Hey thanks for the info. It will come in handy next time I try to convert when I am better prepared. I'm sure it was the particles at the bottom that clogged the sterile filter up. I did use heat but I didn't allow it to settle. My only other question is, Do you think the solution that made it through the sterile filter is good to inject?
Once again, if the tren was dissolved in the magic solution at room temp, its gonna stay dissolved right? So, keeping that in mind, anything you drew an put through the sterile filter is good product. The trick is to let the crap settle and draw carefully to avoid the crap.
Similar threads
