delt shots with a 29G v.test eth?

[wrestletib]

i have been using 3ML 22 G 1.5 needles on my glutes, twice a week, switching between cheeks ( 250mg on mon/fri )


i made a thread earlier asking about delt shots with this exact needle. some said too big, some said too long, etc etc


i also have an abundance of insulin 1cc 29GX1/2 needles that i ordered for my HCG injections, will these work fine on my delts? ive never tried a delt shot, want to make sure i get your opinions before i jab.


thanks bros.

 

[Jacob Creutzfeldt]

That's a very thin needle and perhaps too thin for the test enth. Most brands probably flow easily through a 23 g and extremely slowly through a 25 g. Can you even draw test enth through the 29 g? I'm assuming that if you can draw through it, you can inject through it.

 

[pappad]

I used 23g in my delts with do prob. They were 1 1/2 but I only went about an inch.

 

[TBD 21]

you can use the needles you already have been using for glute shots in your delts. Just make sure you don't fully push in the needle but leave a half inch of it out. fully inject the gear and hold for 30 seconds to make sure it all gets in. The other needle is not ment for test enth.

 

[hesnobradpitt]

That's a very thin needle and perhaps too thin for the test enth. Most brands probably flow easily through a 23 g and extremely slowly through a 25 g. Can you even draw test enth through the 29 g? I'm assuming that if you can draw through it, you can inject through it.

Its been done but with EO gear very thin ,but you have to back fill the pin and i wouldnt do it easyer to get some 25/1inch .

Brad.

 

[Mammoth2500]

If you decide to use it be very careful not to break it as they are pretty fragile and you would be poking into muscle instead of tissue/fat..

 

[eddymerckx]

That's a very thin needle and perhaps too thin for the test enth. Most brands probably flow easily through a 23 g and extremely slowly through a 25 g. Can you even draw test enth through the 29 g? I'm assuming that if you can draw through it, you can inject through it.

agree--spend and hour just trying to draw it out aand you would prob have to push so hard to get it out you would move the neddle around way too much

i am impatient draw everything except h/c/g w/and 18 and pin w/23