Deca shot

[ChrisC]

I just did a 200mg Deca shot and after I removed the needle seemed like it started to slowly spil out from the injection hole with some blood. Is that because I injected it too fast? I use an 1.5' needle and I inserted it in the upper middle area of one of my ass cheeks. I've done several shots now and never saw that before.
Thanks.

 

[manny78]

Could be because you injected too fast. I assume it was 1 cc right ? if so then its weird, the only times I had this problem was when I injected 4 cc at the same time....

 

[XBiker]

Fluid rejection is normal. Try injecting a little slower and leave the pin in your muscle for 10-15 seconds after you inject, which should help the juice absorb.

 

[bambam]

after a while, you build scar tissue in your glutes. I almost always see leakage when I shoot there. Try your quads, delts or calves. A suggestion I saw on another post you might want to try is to have some air at the end of the injection. A small amount is not going to hurt you.

 

[Elephant]

Try pulling the skin up (pinching) on the sides of the injection and rolling the skin some.
Nurses do that to keep injections in the glutes.
They say it twists up the tissue between the pool of juice and the canal from the needle.
Pinch the skin on each side of the injection hole with thumb and index finger, (like you were pinching for body fat) then roll the skin like you were twisting a doobie!

 

[ChrisC]

Thanks everyone for your replys. VERY HELPFULL!!
Yeh it was 1cc
As Manny78 suggested I'll inject it slower and leave the needle in for a few seconds.
Also most of my injections sites have been in my right glute. I'll start using my left one
Thanks Elephant for your reply. I'll try that next time. I have alot of experience roll up (things) so this should be pretty easy.