crystals in test e

[tpilover]

I just got some test e in and notice it has small crystals in it and its also foggy. What should I do and is there any way to heat it up?

Thanks

 

[druncanwaria]

dont think foggyness is a problem.

 

[DannoMight]

heat it up.

 

[druncanwaria]

heat it up.

i predict the thread starters nex post will ask "How?"

 

[DannoMight]

i predict the thread starters nex post will ask "How?"

I'll save him... put it in the oven with a pin in the top.

 

[Cauliflower Ear]

enanthate doenst crystalize...you have cypionate for sure...when that mails from cold areas it comes with crystals in it...but either way it is long estered test so just let is decrystalize

 

[advanced-stealth]

LOL

i predict the thread starters nex post will ask "How?"

 

[bicepts101]

put some water in a pot heat on med put the vial 3/4 submerged in the water

 

[methan_00]

yes usually heating up will help it but make sure when it cools that it doesn't crystilize again, or it can crystilize inside the muscle which you don't want. => cristalisation, probably due to contamination of the solution (bad quality of dissolvement)

 

[methan_00]

some exemple of crystallization by contamination.

 

[tpilover]

yeah thats it...same thing as pic above. I put it in a pot of boiling water with a top part of a neddle in it the vent it and its good as new. will it crystal back up?

 

[puddlemonkey]

The solution used to clean and sterilize the vials wasn't completely dry before the vial was used causing the fogginess. Not a huge issue.

 

[timtim]

yeah thats it...same thing as pic above. I put it in a pot of boiling water with a top part of a neddle in it the vent it and its good as new. will it crystal back up?

if it does you can add 1ml ba and then reheat. that should do the trcik.

 

[mattdan]

yeah thats it...same thing as pic above. I put it in a pot of boiling water with a top part of a neddle in it the vent it and its good as new. will it crystal back up?

Not if you use it fast enough. Shake it up from time to time.

I've had the same thing happen when a high dose bottle sits for a long time.

No worries, you'll be fine.

 

[derekstrong72]

Obviously this forum is full of retards, .....Usually when something crystallizes ,
I t's because it's either overdosed , or the process is not finished properly.
So here is what you do: Take a small pan of cool water and fill it to one quarter or one half inch of water ...Put your bottle of it in the middle of the pan ,...Heat it slowly on low to med. heat , DO NOT LET IT BOIL!!!! When the large bubbles form turn off the heat. Cover and let cool in the water overnight
If the crystals reform you have too muchy drug per cc... otherwise it will not crystalize again. By the way cyp will, enth will, prop will, d-bol will, and most other compounds will crystalize if the process is rushed, or there is too much compound for 1cc. to handle....I.E. D-bol can only be 25mg per cc. most high mg test as 400 plus will crystalize ....hope the info was helpful..... Can't wait to hear the bullshit comments from guys that haven't been around for very long!!!!

 

[tpilover]

Its been a day and still good. with no crystals. Thanks for the info

 

[DannoMight]

Some of the best test cyp I used crystalized.

 

[puddlemonkey]

Obviously this forum is full of retards, .....Usually when something crystallizes ,
I t's because it's either overdosed , or the process is not finished properly.
So here is what you do: Take a small pan of cool water and fill it to one quarter or one half inch of water ...Put your bottle of it in the middle of the pan ,...Heat it slowly on low to med. heat , DO NOT LET IT BOIL!!!! When the large bubbles form turn off the heat. Cover and let cool in the water overnight
If the crystals reform you have too muchy drug per cc... otherwise it will not crystalize again. By the way testosterone cypionate will, testosterone enanthate will, testosterone propionate will, Dianabol - methandrostenolone - will, and most other compounds will crystalize if the process is rushed, or there is too much compound for 1cc. to handle....I.E. D-bol can only be 25mg per cc. most high mg test as 400 plus will crystalize ....hope the info was helpful..... Can't wait to hear the bullshit comments from guys that haven't been around for very long!!!!

Thats why a lot of UGs make both a enanthate and a cypionate test but dose one at 250mg/ml and the other 300mg/ml. Cypionate at the higher mg tends to crystalize quick.

 

[DannoMight]

Thats why a lot of UGs make both a enanthate and a cypionate test but dose one at 250mg/ml and the other 300mg/ml. Cypionate at the higher mg tends to crystalize quick.

the cyp I had crystalize was 250 mg maybe higher.

 

[puddlemonkey]

the testosterone cypionate I had crystalize was 250 mg maybe higher.

Usually higher than 250 and cypionate will do that.

 

[holy ghost]

pudddle wwuuuuuuudddles !

 

[puddlemonkey]

 

[mattdan]

Obviously this forum is full of retards, .....Usually when something crystallizes ,
I t's because it's either overdosed , or the process is not finished properly.
So here is what you do: Take a small pan of cool water and fill it to one quarter or one half inch of water ...Put your bottle of it in the middle of the pan ,...Heat it slowly on low to med. heat , DO NOT LET IT BOIL!!!! When the large bubbles form turn off the heat. Cover and let cool in the water overnight
If the crystals reform you have too muchy drug per cc... otherwise it will not crystalize again. By the way testosterone cypionate will, testosterone enanthate will, testosterone propionate will, Dianabol - methandrostenolone - will, and most other compounds will crystalize if the process is rushed, or there is too much compound for 1cc. to handle....I.E. D-bol can only be 25mg per cc. most high mg test as 400 plus will crystalize ....hope the info was helpful..... Can't wait to hear the bullshit comments from guys that haven't been around for very long!!!!

For talking smack, you sure didn't give a very complete answer. Over dosing is NOT the only thing that could make it crystalize. But since you're the real pro I won't go into the other reasons.

Also, it's ok to boil as long as the bottle isn't resting directly on the bottom of the pan. Surprised someone so knowledgable didn't know that.

 

[derekstrong72]

For talking smack, you sure didn't give a very complete answer. Over dosing is NOT the only thing that could make it crystalize. But since you're the real pro I won't go into the other reasons.

Also, it's ok to boil as long as the bottle isn't resting directly on the bottom of the pan. Surprised someone so knowledgable didn't know that.

as I knew someone would reply shittily ... I was just trying to let the kid know what to do. And if you read my thread you will notice that I did not say overdosing was the only reason ....Sorry for being in the know.