cooking off the benzyl alcohol in IP gear

[rainbow22]

i've been giving IP injectables a try and while i'm very satisfied with my gains in both size and strength, i need to get some of this BA out from them because i do not have superhuman pain tolerance. i have already had the flasks uncapped in a 220 degree oven for 45 minutes. i could smell the alcohol very distinctly so i know alot evaporated but clearly more needs to go because injections remain excrutiating. any recommendation? wait let me rephrase that. any recommendations aside from refraining to buy IP gear?

 

[djdjdjddjon]

hahah, no not really. i dont wanna burst your bubble but from what i've read you CANNOT remove ba from solution. its bp is like 400 degreess, at that temp your risking blowing it up or destroying your gear. i realy dont think this is possible if i had my orgo chem book i'd look it up...ah found on this site, 206degress C, and 401 degress farenhiet...so, once again i dont think thats going to happen without destroying your gear. also im not sure what your using but the melting point for plain test is 155C.

dj

common boiling points: (http://www.orcbs.msu.edu/chemical/chp/appendixd.html)

 

[rainbow22]

BA

i wont dispute what the boiling point of BA is but i'm telling you that it is possible to remove some of the benzyl by using the method i employed. the reason is this. lets use water for an example. when we boil water it will have to reach 100 celcius. BUT steam will be rolling off the water long before that temperature is reached. same holds true for BA. when i did it, it wreaked of alcohol.

 

[hookuprx]

Re: BA

i wont dispute what the boiling point of BA is but i'm telling you that it is possible to remove some of the benzyl by using the method i employed. the reason is this. lets use water for an example. when we boil water it will have to reach 100 celcius. BUT steam will be rolling off the water long before that temperature is reached. same holds true for BA. when i did it, it wreaked of alcohol.

Consequently, your test has a much lower boiling point - therefore not only is the alcohol being 'steamed' out, there is a good chance other important things are as well.

thederrickm

 

[scott825]

Is that stuff really worth all the worries & time? I dont even think people should be allowed to talk about IP shit on this board.I think we are above that here..

Sorry had to do it,lol

 

[gambit7666]

Just add in some usp grade oil and dilute it by half, you'll double your volume but decrease your pain. simple enough